V680-HAM42-DRT Omron, V680-HAM42-DRT Datasheet - Page 10

• Manufacturer Part Number: V680-HAM42-DRT
• Description: V680 DeviceNet RFID Ctrl
• Manufacturer: Omron

Specifications of V680-HAM42-DRT

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

V680-HAM91/-HAM81
Parts Names
Main Functions
Other Functions
Operating Modes
Note 1. If an error occurs, the error code will not be output to the data output lines (OD0 to OD15).
10
Reading
Writing
Address Shift
Noise Check
Write Protection
Function
Reading
Writing
Parity check output (See note 3.)
Noise check function
Address shift function
Connects to a PLC or other host using an Interface Cable (V680-A60).
Connects to a PLC or other host using an Interface Cable (V680-A60).
This connector is not required if data will not be written to ID Tags or the address
shift function and noise check function will not be used.
I/O connector CN1
I/O connector CN2
Access Address Mode Setting Switch
Sets the memory address in the ID Tag that
will be accessed.
2. If an error occurs, the data output lines will all turn ON.
3. The parity is also output when the error code is output.
4. The V600-compatible modes are for compatibility with the previous V600 Series. Not all functions are supported in these modes.
16 bits
Verification Check
Wire-saving Mode (See note 2.)
8 bits (1 byte)
16 bits (2 bytes)
Individual bits (BIT SET or BIT CLEAR) ●
V680-HAM42-DRT, V680-HAM91/-HAM81
Data Read
Verify
Wire-saving Mode The wire-saving mode enables reading and writing 16-bit data using one 16-point Input Unit for a PLC
Data Write
Bit Set
Bit Clear
When reading or writing more than 16 bits (2 bytes), an address shift can be specified to enable reading or writing up to
128 bits (16 addresses). The address shift can be set from the host, eliminating the need to change the address set on the
front panel.
Measures the noise around the Antenna.
Prevents data stored in the ID Tag from being overwritten.
Reads 16 bits of data from the set address in the ID Tag and outputs the data to the data output lines.
Compares the code set in advance with the code read from the ID Tag and outputs the match/mismatch
result.
or other host device.
Writes the data specified in the data input lines. (The user can select to batch-write 16 bits or 8 bits.)
Sets specified bits.
Clears specifies bits.
Mode
●
●
●
●
●
●
●
●
TRIGGER MODE 1
Standard modes
AUTO MODE 1
Indicators
Mode Setting Switches
Access Mode Setting
Output Mode Setting
Read Mode Setting
Write Mode Setting
Antenna Connector
Indicates the ID Flag Sensor status and ID Tag communications status.
Sets the operating mode (SYNC or AUTO) for communications with the ID Tag,
and sets the Noise Measurement Mode. (Refer to the following table.)
Sets the Output Mode (10-ms, 50-ms, or 500-ms OFF-delay), and output
time setting (10-ms, 50-ms, 500-ms, or Continuous output).
Sets the mode for reading from an ID Tag DATA READ, VERIFY,
or Wire-saving Mode.
Sets the mode used when writing
(16-bit write/8-bit write, BIT SET/BIT CLEAR).
Connects to a V680-series Antenna (V680-HS@).
(●) (See note 1.)
●
●
●
●
HAM91/81-compatible
V600-HAR91/81 and
TRIGGER MODE 2
AUTO MODE 2
modes
●
●
●
V600-HAR92-compatible
TRIGGER MODE 3
AUTO MODE 3
modes