DP-DSG2 METCAL, DP-DSG2 Datasheet - Page 14
![no-image](/images/no-image-200.jpg)
DP-DSG2
Manufacturer Part Number
DP-DSG2
Description
Desoldering Tool Assembly
Manufacturer
METCAL
Datasheet
1.DP-DSG2.pdf
(28 pages)
Specifications of DP-DSG2
Accessory Type
Desolder Tool Assembly
Peak Reflow Compatible (260 C)
No
Leaded Process Compatible
No
For Use With
OK Internationals Metcal SP440-21 Desoldering Station
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
SMTC specialty tip cartridges for MX systems
Pad clean-up
Metcal’s blade tip cartridges may be used with desolder braid to
clean up the pads for both two and four-sided components
regardless of the lead configuration or pitch.
For proper wicking, always use the tip by working with the grain
of the pad. Never use a blade to wick by dragging it down the
row of pads. The heat combined with the abrasive action may
cause the epoxy holding the land to the board to lift the pad.
Choose the size of blade tip that best fits the row of pads. For
optimum heat delivery, use the recommended part number
below to order.
Please note that dual cartridges require 2 power supplies and 2
handpieces. A dual handle support (DHS) is also recommended.
Other special tip cartridges
12
Dimension in inches
0.410 Long
0.620 Long
0.830 Long
1.550 Long Dual
Hot Plate (.425in. sq.) SMTC-x136
28-Pin SMT Connector SMTC-x98
Recommended Part Number
SMTC-060
SMTC-061
SMTC-062
SMTC-1110
Multi-lead speed soldering
Metcal makes special tip cartridges for replacing most component
configurations, gull-wing and J-lead, regardless of the number of
leads or the lead pitch. We call these multi-lead speed soldering
tip cartridges.
For components on boards where access is not a problem, we
recommend our SMTC-x147 “hoof” tip cartridge. (This tip
cartridge is shaped like a horse’s hoof) This tip is designed
specifically for “drag soldering” techniques. The face holds just
the right amount of solder, and the SMTC-x147 has extra
plating where necessary to prevent the failures so commonly
seen when using a bent hook to drag solder. Once you have
practiced a bit, you will find it is the easiest and fastest way to
solder surface mount components.
The “knife” tip (SMTC-x161) is designed for multi-lead soldering
of PLCC’s in tight spaces. The “mini-hoof” (SMTC-x167) is
designed for soldering of either PLCC’s or QFP’s in tight spaces.
See your local Metcal distributor or representative for a
demonstration of these easy techniques.
Please note:
x = 5 for 500 Series; x = 0 for 600 Series; x = 1 for 700 Series.
Note
SMTC rework cartridges are for use with MX-RM3E
soldering/rework handpieces for STSS/MX systems only.
They cannot be used with SP systems, Talon handpieces, or
desolder handpieces.
Style
Hoof
Mini-Hoof
Knife
Recommended Part Number
SMTC-x147
SMTC-x167
SMTC-x161