M4SARC OPTO 22, M4SARC Datasheet - Page 3
![Computers, Interface Cards](/photos/21/57/215775/4085212_sml.jpg)
M4SARC
Manufacturer Part Number
M4SARC
Description
Computers, Interface Cards
Manufacturer
OPTO 22
Datasheet
1.M4SARC.pdf
(7 pages)
Specifications of M4SARC
Leaded Process Compatible
No
Peak Reflow Compatible (260 C)
No
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
DATA SHEET
Form 631-040823
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • Phone: (951) 695-3000 • (800) 321-OPTO • Fax: (951) 695-3095 • www.opto22.com
M4SARC System Architecture
Installation
controller with other Opto 22 M4 ARCNET cards such as the
M4DUALARC or M4SARCF.
all unused ARCNET nodes and nodes located at the physical end of
the ARCNET network. This termination is required for the controller
and the interface card to operate correctly.
The M4SARC interface card can be installed in an M4-family
Note: Before installing and activating the M4SARC, terminate
© 2004 Opto 22. All rights reserved. All trademarks, trade names, logos, and service marks referenced herein belong to their respective companies.
Inside Sales: (800) 321-OPTO • Product Support: (800) TEK-OPTO • (951) 695-3080 • Fax: (951) 695-3017 • Email: sales@opto22.com
M4SARC Network Configuration
Preparing the Card for Installation
and does not need to be terminated.
on the M4SARC card. This jumper is not used, and the interface
card will not operate if this jumper is terminated.
The M4SARC interface card itself has built-in termination
Note: Do not install a terminating jumper on the TERM jumper
INTERFACES
CONTROLLERS
MODULAR
page 3/7