DTX-MFM2 FLUKE NETWORKS, DTX-MFM2 Datasheet - Page 40

• Manufacturer Part Number: DTX-MFM2
• Description: DTX-MFM2 REPLACEMENT FOR DTX-MFM
• Manufacturer: FLUKE NETWORKS

Specifications of DTX-MFM2

• Multimode Fiber Module Set: ROHS COMPLIANT

DTX-MFM2/GFM2/SFM2 Fiber Modules
Users Manual
34
Autotest in Loopback Mode: Test the Fiber
11 Clean and inspect the connectors on the cabling to be
12 Turn the rotary switch to AUTOTEST. Verify that the
If you disconnected the test reference cord from
the tester’s output port, you must set the
reference again to ensure valid measurements.
tested; then connect to the cabling. The tester shows
connections for the test method you selected. Figure 12
shows connections for the 1 Jumper method.
media type is set to Fiber Loss. Press
Media to change it if necessary.
W
Caution
J
Change
13 Press
14 If bi-directional testing is enabled, the tester prompts
15 To save the results, press
you to switch the fibers halfway through the test.
Switch the fibers at the adapters (not at the tester’s
ports).
then press
P
.
N
again.
N
, select or create a fiber ID;