CL1F3201UK Souriau Connection Technology, CL1F3201UK Datasheet - Page 22

PLUG, FREE, SOCKET, FAB KIT, 31WAY

CL1F3201UK

Manufacturer Part Number
CL1F3201UK
Description
PLUG, FREE, SOCKET, FAB KIT, 31WAY
Manufacturer
Souriau Connection Technology
Series
Clipperr
Datasheet

Specifications of CL1F3201UK

Connector Body Material
Thermoplastic
Gender
Plug
Connector Mounting
Cable Mount
Connector Shell Size
3
Insert Arrangement
3-31
Connector Type
Circular Industrial
Instruction For Assembly
Adaptor and PG electrical thread backshells
The CLIPPER connector must be equipped with an
adaptor in order to use a PG electrical thread backshell
(e.g.: cable clamp or sealing gland, or flexible conduits
system backshells, etc.)
Grommet Backshell Assembly
1) Position the O-ring at the bottom of the backnut.
2) Run the backnut around the cable.
3) Unlock the retainer plate.
4) Position the grommet in the thrust ring, resting
5) Insert the contacts through the grommet and the
6) Lock the retainer plate.
7) Screw the backshell.
22
against the retainer plate.
retainer plate.
Grommet
1) Manually, fully screw the adaptor on
2) In the sealed version, cover the
3) Manually, fully screw the PG thread
Note: In the case of an elbow backshell, it is
possible to adjust the position according to
the angle desired.
the connector, the hexagonal nut
towards the rear.
O-ring.
backshell of your choice.
Thrust ring
O ring
CLIPPER
Heat shrink boot
Shrink sleeve as follows :
1) Use heat gun with an air deflector nozzle.
2) Adjust air deflector opening to accommodate tubing
3) Position the air deflector over section of tubing to be
4) When tubing begins to shrink, move gun so that air
5) Move nozzle to adjacent section and shrink in the
Avoid excessive heat. Direct heat away from connector
assembly to prevent damage.
Instruction for polarizing connector mounting
When the insert is partially filled with contacts, place
polarization contact into selected hole location in the
FEMALE INSERT and push in until seated.
• Polarization contacts are used to provide keying
• Polarization contacts are used in the socket-cavities
In order to lock the couple of chosen connectors, you
have to let free the cavity in front of the polarization
contact.
To avoid the connection with other connectors, you
have to insert a contact in the cavity in front of the
polarization contact.
capabilities for the CLIPPER series.
of standard plugs and reverse receptacles.
size. Turn switch ON. Wait until full heat output is
reached.
shrunk. Start at pre-shrunk section and work
towards open end.
is distributed in a band around the tubing
circumference causing it to shrink evenly around the
cable.
same manner. Repeat process on section at a time
until entire length is shrunk.
CP16SW9700

Related parts for CL1F3201UK