ATA5811-PLQW Atmel, ATA5811-PLQW Datasheet - Page 42

• Manufacturer Part Number: ATA5811-PLQW
• Description: RF Transceiver RF DATA CONTROL Transceiver
• Manufacturer: Atmel

Specifications of ATA5811-PLQW

• Operating Supply Voltage: 2.5 V, 3.3 V, 5 V
• Mounting Style: SMD/SMT
• Package / Case: QFN-48 EP
• Minimum Operating Temperature: - 40 C
• Operating Temperature (min): -40C
• Operating Temperature (max): 105C
• Operating Temperature Classification: Industrial
• Product Depth (mm): 7mm
• Product Height (mm): 0.9mm
• Product Length (mm): 7mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

42
ATA5811/ATA5812
If the transceiver is in any active mode (Idle, AUX, TX, RX, RX_Polling), an integrated debounce
logic is active. If there is an event on pin Tn a debounce counter is set to 0 (T = 0) and started.
The status is updated, an interrupt is issued and the debounce counter is stopped after reaching
the counter value T = 8195
An event on the same key input before reaching T = 8195
An event on an other key input before reaching T = 8195
debounce counter.
While the debounce counter is running, the bits VSOUT_EN and CLK_ON in control register 3
are set to 1.
The interrupt is deleted after reading the status register or executes the command Delete_IRQ.
If a pin Tn is not used, it can be left open because of an internal pull-up resistor (typically 50 k ).
Figure 9-3.
Timing Flow Pin Tn, Status Bit STn
Start debounce counter
Stop debounce counter
RX Polling Mode or
Event on Pin Tn ?
Event on Pin Tn ?
IDLE Mode or
AUX Mode or
TX Mode or
Tn = STn ?
RX Mode
T = 0
Y
Y
Y
T
DCLK
N
N
N
.
Stop debounce counter
T = 8195
Pin Tn = 0 ?
STn = 1
IRQ = 1
Y
Y
T ?
N
N
T
DCLK
Stop debounce counter
T
DCLK
stops the debounce counter.
STn = 0
IRQ = 1
resets and restarts the
4689F–RKE–08/06