104068-5 TE Connectivity, 104068-5 Datasheet - Page 5

• Manufacturer Part Number: 104068-5
• Description: Conn Shrouded Header HDR 50 POS 1.27mm Solder ST Thru-Hole Tube
• Manufacturer: TE Connectivity
• Type: Shrouded Headerr

Specifications of 104068-5

• Pitch: 1.27 mm
• Number Of Rows: 2
• Number Of Contacts: 50
• Gender: HDR
• Contact Plating: Gold Over Nickel
• Termination Method: Solder
• Peak Reflow Compatible (260 C): No
• Terminal Type: Straight PCB Thru Hole
• Connector Shroud: Yes
• Body Material: Thermoplastic
• Leaded Process Compatible: No
• Rohs Compliant: No
• Connector Type: Header
• Shrouded: Yes
• Mount Angle: Vertical
• Pcb Mount Style: Through Hole
• Pcb Mount Retention: Without
• Voltage (vac): 30
• Insulation Resistance (m?): 5,000
• Dielectric Withstanding Voltage (v): 500
• Termination Post Length (mm [in]): 2.54 [0.100]
• Solder Tail Contact Plating: Tin-Lead
• Number Of Positions: 50
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold (30)
• Connector Style: Plug
• Housing Material: Thermoplastic - GF
• Ul Flammability Rating: UL 94V-0
• Housing Color: Black
• Rohs/elv Compliance: ELV compliant, 5 of 6 Compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C, Reflow solder capable to 245°C, Reflow solder capable to 260°C, Pin-in-Paste capable to 245°C, Pin-in-Paste capable to 260°C
• Approved Standards: UL E28476, CSA LR7189
• Temperature Range (°c): -65 – +105
• Packaging Method: Tube

4.
4.1.
4.2.
4.3.
4.4.
Rev C
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. When
product failure occurs, corrective action shall be taken and specimens resubmitted for qualification.
Testing to confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. All test groups shall consist of a minimum of 5
specimens.
Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figure 2.
108-1579
5 of 8