ATA6661-TAQ Atmel, ATA6661-TAQ Datasheet - Page 3

• Manufacturer Part Number: ATA6661-TAQ
• Manufacturer: Atmel

Specifications of ATA6661-TAQ

• Number Of Transmitters: 1
• Power Supply Requirement: Single
• Package Type: SO
• Operating Temperature Classification: Automotive
• Mounting: Surface Mount
• Pin Count: 8
• Operating Temperature (max): 125C
• Operating Temperature (min): -40C
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Lead Free Status / RoHS Status: Not Compliant

3. Functional Description
3.1
3.2
3.3
3.4
3.5
3.6
4729M–AUTO–02/09
Supply Pin (V
Ground Pin (GND)
Bus Pin (LIN)
Input Pin (TXD)
TXD Dominant Time-out Function
Output Pin (RXD)
S
Undervoltage detection is implemented to disable transmission if V
5V to avoid false bus messages. After switching on V
INHIBIT is switched on. The supply current in sleep mode is typically 10 µA.
The ATA6661 is neutral on the LIN pin in case of a GND disconnection. It is able to handle a
ground shift up to 3V for V
A low-side driver with internal current limitation and thermal shutdown as well as an internal
pull-up resistor according to LIN specification 2.0 are implemented. The voltage range is from
–27V to +60V. This pin exhibits no reverse current from the LIN bus to V
GND shift or V
specification.The fall time (from recessive to dominant) and the rise time (from dominant to
recessive) are slope controlled. The output has a short circuit limitation. This is a self adapting
current limitation; i.e., during current limitation as the chip temperature increases so the current
reduces.
This pin is the microcontroller interface to control the state of the LIN output. TXD is low to bring
LIN low. If TXD is high, the LIN output transistor is turned off. In this case, the bus is in recessive
mode via the internal pull-up resistor. The TXD pin is compatible to a 3.3V and 5V supply.
The TXD input has an internal pull-down resistor. An internal timer prevents the bus line from
being driven permanently in dominant state. If TXD is forced low longer than t
LIN will be switched off to recessive mode. To reset this mode switch TXD to high (>10 µs)
before switching LIN to dominant again.
This pin reports to the microcontroller the state of the LIN bus. LIN high (recessive) is reported
by a high level at RXD, LIN low (dominant) is reported by a low voltage at RXD. The output is an
open drain, therefore, it is compatible to a 3.3V or 5V power supply. The AC characteristics are
defined with a pull-up resistor of 5 k to 5V and a load capacitor of 20 pF. The output is short-cur-
rent protected. In unpowered mode (V
diode is implemented with V
)
Batt
disconnection. The LIN receiver thresholds are compatible to the LIN protocol
S
> 9V.
Z
= 6.1V.
S
= 0V), RXD is switched off. For ESD protection a Zener
S
the IC switches to pre-normal mode and
S
is falling to a value below
S
, even in case of a
dom
ATA6661
> 6 ms, the pin
3