NRT-C Omron, NRT-C Datasheet - Page 8

• Manufacturer Part Number: NRT-C
• Description: SWITCH
• Manufacturer: Omron

Specifications of NRT-C

• Leaded Process Compatible: Yes
• Peak Reflow Compatible (260 C): Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: M7E Series Digital Displays
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: NRTC; Q3652747

Safety Precautions for M7E
■ Precautions for Correct Use
Display Units
Installation environment
• Use the Unit in locations that are not subject to organic solvents
• These Display Units are designed for indoor use only.
• Use the Units in areas not subject to vibration or shock in excess of
Mounting
Connector Insertion
When inserting the connector,
make sure that the UP arrow is
pointing upwards.
• When the End Plates are linked,
• Link the Units by snapping the
• To undo the linkage, use a slotted
(thinner, benzene, etc.), strong alkali, strong acid, sunlight, and
corrosive gases.
Visibility may be significantly reduced if the Unit is used outside or
in locations where the ambient brightness exceeds the brightness
of the M7E. The product is not drip-proof. Use the product where it
will not be subject to water or oil splashing.
specifications.
the entire set can be quickly
mounted and fastened to a
panel. Confirm that the links
between units and End Plates
are secure, and then securely
fasten the End Plate tips to the
panel.
projecting tips and slots together.
screwdriver as shown in the
following figure and press the upper
and lower tips while separating.
http://www.ia.omron.com/
Projecting tip
Slot
Connector
Panel
Wiring and Connections
Make sure that no wire is more than five meters long when wiring.
Handling
There are projecting tips made of resin on the side of each Display
Unit. Be sure not to drop the Display Unit, otherwise the projecting
tips may break.
Procedure for Making Face Plates for
M7E-01 Unit Display Unit
Custom face plates can be made according to the following
guidelines.
1. Prepare a blank Unit Display Unit (M7E-01UR2-A or M7E-
2. Take transparent polyester film (with thickness equivalent to
3. Print solid black on the film covering all areas except the
4. Install the completed face plate into the Unit Display Unit.
Mother Board
Wiring and
Connections
Secure the cable and lead
wires with the panel so that no
excessive force will be
imposed on the input
connector or power supply
terminals.
01UG2-A) for the desired lighting color.
0.188) and cut it to the following dimensions.
character and so that the desired unit character is within the
character display range (with the unit character transparent).
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
Face plate now completed
(not included with
the M7E-01U@2-A)
Filter
5
7
Face plate dimensions
Character display range
18.6
11
−0.3
0
Surface-lighting LED (red)
31
−0.3
0
C-1