LM1267NA National Semiconductor, LM1267NA Datasheet - Page 12

• Manufacturer Part Number: LM1267NA
• Manufacturer: National Semiconductor

Specifications of LM1267NA

• Power Supply Requirement: Single
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Mounting: Through Hole
• Pin Count: 24
• Package Type: MDIP
• Lead Free Status / RoHS Status: Not Compliant

www.national.com
Functional Description
H Flyback: H Flyback is an analog signal input from the
monitor horizontal scan. The “H Blank” section uses this
signal to add horizontal blanking to the output video signal.
This enables the user to blank at the cathodes during hori-
zontal flyback. An optional capacitor and/or resistor to
ground may be needed if noise interferes with the H Flyback
signal.
This feature gives very accurate timing for the horizontal
blanking; however, the flyback signal must be very clean.
There should be no ringing or other noise on the flyback
signal.
R
value of + 1 mA during flyback and −100 µA during normal
forward scan. For example if an H flyback with a peak of
100V is used, R
of pin 24 is low to limit the maximum voltage swing at the
input to within the supply rail and ground. The IC interface
circuit creates a digital signal from this waveform, which is
used as the blanking signal at the “Output Buffer Amp”. This
signal adds blanking to the video output signal. Figure 5
shows the H flyback waveforms and the location of R
56 pF capacitor has been added to the H Flyback pin on the
demo board for filtering noise on the H Flyback signal.
LIMIT
is used to limit the input current into the IC to a typical
LIMIT
= 100 k . The internal input impedance
FIGURE 4. ABL
(Continued)
LIMIT
DS200050-26
. A
12
H Blank: Some customers may still prefer to use a standard
logic signal for the horizontal blanking. Pin 24 can be
adapted to accept a logic input. It is necessary for the current
flow into pin 24 to reverse for proper operation. Therefore the
logic signal must be AC coupled into pin 24. Figure 6 shows
the recommended circuit for a logic signal input. The blank
signal must be a positive pulse.
Power Save Mode: There are two modes of power save:
1. Blanking the video
2. Turning off most of the power for maximum power sav-
In the first mode the video is completely blanked. By setting
bit-0 in register 9 to a 1 the video will be completely blanked.
This gives some power savings since there is no beam
current in the monitor. Maximum power saving is obtained in
the second mode. Bits 0 and 1 in register 9 should be set to
a 1. Bit 1 in register 9 turns off the video output stage of the
ings.
FIGURE 6. Standard Logic H Blank
FIGURE 5. H Flyback Input Pulse
DS200050-28
DS200050-27