MC34910G5AC Freescale, MC34910G5AC Datasheet - Page 34
![](/photos/31/26/312678/296-32-tqfp_sml.jpg)
MC34910G5AC
Manufacturer Part Number
MC34910G5AC
Description
Manufacturer
Freescale
Datasheet
1.MC34910G5AC.pdf
(90 pages)
Specifications of MC34910G5AC
Turn Off Delay Time
10us
Number Of Drivers
2
Operating Temperature (min)
-40C
Lead Free Status / RoHS Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
MC34910G5AC
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Company:
Part Number:
MC34910G5ACR2
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
Open Load Detection
current through the high side is below the open load current
threshold.
and HS2OP in the High Side Status Register (HSSR).
Current Limitation
combination with the over-temperature shutdown the high-
side drivers are protected against over-current and short-
circuit failures.
indicated with the bits HS1CL and HS2CL in the HSSR.
excessive power might be dissipated.
Over-temperature Protection (HS Interrupt)
temperature. In case of an over-temperature condition both
high side drivers are shut down and the event is latched in the
Interrupt Control Module. The shutdown is indicated as HS
Interrupt in the Interrupt Source Register (ISR).
setting all HSxOP and HSxCL bits simultaneously.
then an interrupt (IRQ) is generated.
34
33910
FUNCTIONAL DEVICE OPERATIONS
OPERATIONAL MODES
Each high side driver signals an open load condition if the
The open load condition is indicated with the bits HS1OP
Each high side driver has an output current limitation. In
When the driver operates in the current limitation area, it is
Note: If the driver is operating in current limitation mode,
Both high side drivers are protected against over-
A thermal shutdown of the high side drivers is indicated by
If the bit HSM is set in the Interrupt Mask Register (IMR),
MOD1:2
HSxOP
HSxCL
HVSE
HSx
Interrupt
Wakeup
Module
Module
Control
Control
Status
on/off
Figure 17. High Side Drivers HS1 and HS2
over-temperture shutdown (interrupt maskable)
high voltage shutdown (maskable)
High Side Driver
open load detection
current limitation
charge pump
the over-temperature condition is gone, will re-enable the
high side drivers.
High-voltage Shutdown
shutdown is enabled (bit HVSE in the Mode Control Register
(MCR) is set both high side drivers are shut down.
the high voltage condition is gone, will re-enable the high side
drivers.
Sleep And Stop Mode
and Stop mode for cyclic sensing. Also see
Operating Modes
LIN PHYSICAL LAYER
communication in automotive applications. The LIN physical
layer is designed to meet the LIN physical layer specification
and has the following features:
shutdown. An internal pull-up resistor with a serial diode
structure is integrated, so no external pull-up components are
A write to the High Side Control Register (HSCR), when
In case of a high voltage condition and if the high voltage
A write to the High Side Control Register (HSCR), when
The high side drivers can be enabled to operate in Sleep
The LIN bus pin provides a physical layer for single-wire
• LIN physical layer 2.0, 2.1 and SAEJ2602 compliant
• Slew rate selection
• Over-temperature shutdown
• Advanced diagnostics
The LIN driver is a low side MOSFET with thermal
PWMHSx
Overview.
V
DD
Analog Integrated Circuit Device Data
Freescale Semiconductor
VS2
V
DD
Table 6,
PWMIN
HSx