5962-9071506MUA QP SEMICONDUCTOR, 5962-9071506MUA Datasheet - Page 3

• Manufacturer Part Number: 5962-9071506MUA
• Manufacturer: QP SEMICONDUCTOR

Specifications of 5962-9071506MUA

• Lead Free Status / RoHS Status: Not Compliant

DSCC FORM 2234
APR 97
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
(Copies of these documents are available online at
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
1/
2/
_______
1.3 Absolute maximum ratings. 1/
1.4 Recommended operating conditions.
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
Supply voltage range to ground potential (V
DC voltage range applied to outputs in high-Z state ..................-0.5 V dc to +7.0 V dc
DC input voltage range (V
DC output current....................................................................... 20 mA
Maximum power dissipation ....................................................... 1.0 W
Lead temperature (soldering, 10 seconds).................................+260°C
Thermal resistance, junction-to-case (θ
Junction temperature (T
Storage temperature range (T
Temperature under bias range...................................................-55°C to +125°C
Supply voltage range (V
Ground voltage (GND) ............................................................... 0 V dc
Input high voltage (V
Input low voltage (V
Case operating temperature range (T
DEPARTMENT OF DEFENSE SPECIFICATION
DEPARTMENT OF DEFENSE STANDARDS
DEPARTMENT OF DEFENSE HANDBOOKS
maximum levels may degrade performance and affect reliability.
Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
V
IH
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
MIL-STD-883
MIL-STD-1835 -
MIL-HDBK-103 -
MIL-HDBK-780 -
is 2.2 V minimum for all input pins except XI which is 3.5 V minimum.
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
STANDARD
-
IL
IH
) ................................................................ 0.8 V dc maximum
Test Method Standard Microcircuits.
Interface Standard Electronic Component Case Outlines.
List of Standard Microcircuit Drawings.
Standard Microcircuit Drawings.
)............................................................... 2.2 V dc minimum 2/
J
CC
)...........................................................+175°C
IN
) ........................................................+4.5 V dc minimum to +5.5 V dc maximum
) ......................................................-0.5 V dc to V
STG
) .............................................-65°C to +150°C
C
) .....................................-55°C to +125°C
JC
) ................................. See MIL-STD-1835
CC
)..........................-0.5 V dc to +7.0 V dc
http://assist.daps.dla.mil/quicksearch/
SIZE
A
CC
REVISION LEVEL
+.5 V dc
or
http://assist.daps.dla.mil
B
SHEET
5962-90715
or from the
3