HB28K032MM3 Renesas Electronics America, HB28K032MM3 Datasheet - Page 65

• Manufacturer Part Number: HB28K032MM3
• Manufacturer: Renesas Electronics America
• Type: MultiMedia Cardr

Specifications of HB28K032MM3

• Density: 32MByte
• Operating Supply Voltage (typ): 3.3V
• Operating Temperature (min): -25C
• Operating Temperature (max): 85C
• Package Type: Not Required
• Mounting: Surface Mount
• Pin Count: 7
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Programmable: Yes
• Lead Free Status / RoHS Status: Compliant

HB28K032/L064/J128/J256/J512MM3, HB28K032/L064/J128/J256RM3
This response token is two bytes long and sent as a response to the SEND_STATUS command. The
format is given in Figure “R2 Response Format”.
The first byte is identical to the response R1. The content of the second byte is described in the following:
Rev.0.02, Sep.15.2004, page 65 of 89
Format R2
0
7
argument was out of its valid range or if the host is trying to change the ROM section or reverse
the copy bit (set as original) or permanent WP bit (un-protect) of the CSD register.
overloaded. It is set when the host attempts to erase a write protected sector or if a sequence or
password error occurred during card lock/unlock operation.
Out of range
Erase param: An invalid selection, groups, for erase.
Write protect violation: The command tried to write a write protected block.
Card ECC failed: Card internal ECC was applied but failed to correct the data.
CC error: Internal card controller error
Error: A general or an unknown error occurred during the operation.
Write protect erase skip
Card is locked: Set when the card is locked by the user. Reset when it is unlocked.
1. Byte
csd_overwrite: This status bit has two functions. It is set if the command
0
7
lock/unlock command failed: This status bit has two functions
2. Byte
R2 Response Format
0
card is locked
wp erase skip | lock/unlock command failed
error
CC error
card ecc failed
wp violation
erase param
out of range | csd_overwrite
in idle state
erase reset
illegal command
com crc error
erase sequence error
address error
parameter error