5962-89841053A E2V, 5962-89841053A Datasheet - Page 9

• Manufacturer Part Number: 5962-89841053A
• Manufacturer: E2V

Specifications of 5962-89841053A

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DEFENSE SUPPLY CENTER COLUMBUS
DSCC FORM 2234
APR 97
COLUMBUS, OHIO 43218-3990
1/ The maximum leakage current is due to the internal pull-up resistor on all pins.
2/ See figure 6 for the I/V curve for ppk (bus friendly pin keeper).
3/ These are absolute values with respect to device ground and all overshoots due to system or tester noise are
4/ Not more than one output at a time should be shorted. Short circuit test duration should not exceed 1 second (see
5/ AC tests are performed with input rise and fall times (10 percent to 90 percent) of 3.0 ns, timing reference levels of
6/ Test applies only to registered outputs.
7/ Transition is measured at steady-state high level -500 mV or steady-state low level +500 mV on the output from the
8/ Tested initially and after any design or process changes that affect that parameter, and therefore shall be
MICROCIRCUIT DRAWING
included.
4.3.1d).
1.5 V, input pulse levels of 0 V to 3.0 V and the output load of figure 3. Input pulse levels are absolute values with
respect to device ground and all overshoots due to system or tester noise are included.
1.5 V level on the input.
guaranteed to the limits specified in table I.
STANDARD
* PDA applies to subgroups 1 and 7
** See 4.3.1c
MIL-STD-883 test requirements
Interim electrical parameters
(method 5004)
Final electrical test parameters
(method 5004)
Group A test requirements
(method 5005)
Groups C and D end-point
Electrical parameters
(method 5005)
Table I. Electrical performance characteristics - Continued.
TABLE II. Electrical test requirements.
SIZE
A
REVISION LEVEL
MIL-STD-883, method 5005,
(in accordance with
1, 2,3, 4**, 7, 8A,
1*, 2,3, 7*, 8A,
2, 3, 7, 8A, 8B
8B, 9, 10, 11
8B, 9, 10, 11
Subgroups
L
table I)
- - -
SHEET
5962-89841
9