SI5326A-C-GM Silicon Laboratories Inc, SI5326A-C-GM Datasheet - Page 54

• Manufacturer Part Number: SI5326A-C-GM
• Description: IC ANY-RATE MULTI/ATTEN 36-QFN
• Manufacturer: Silicon Laboratories Inc
• Type: Clock Multiplierr

Specifications of SI5326A-C-GM

• Package / Case: 36-QFN
• Pll: Yes
• Input: Clock
• Output: CML, CMOS, LVDS, LVPECL
• Number Of Circuits: 1
• Ratio - Input:output: 2:2
• Differential - Input:output: Yes/Yes
• Frequency - Max: 1.4GHz
• Divider/multiplier: Yes/Yes
• Voltage - Supply: 1.71 V ~ 3.63 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Frequency-max: 1.4GHz
• Max Input Freq: 710 MHz
• Max Output Freq: 945 MHz
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Number Of Outputs: 2
• Supply Current: 251 mA
• Supply Voltage (max): 3.3 V
• Supply Voltage (min): 1.8 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Si5326
Reset value = 0000 0000
54
Register 136.
Name
Type
5:0
Bit
Bit
7
6
RST_REG
RST_REG
Reserved
R/W
Name
D7
ICAL
Internal Reset (Same as Pin Reset).
Note: The I
0: Normal operation.
1: Reset of all internal logic. Outputs disabled or tristated during reset.
Start an Internal Calibration Sequence.
For proper operation, the device must go through an internal calibration sequence. ICAL
is a self-clearing bit. Writing a “1” to this location initiates an ICAL. The calibration is com-
plete once the LOL alarm goes low.
0: Normal operation.
1: Writing a "1" initiates internal self-calibration. Upon completion of internal self-calibra-
tion, LOL will go low.
Notes:
Reserved.
ICAL
R/W
D6
1. A valid stable clock (within 100 ppm) must be present to begin ICAL.
2. If the input changes by more than 500 ppm, the part may do an autonomous ICAL.
3. See Table 9, “Register Locations Requiring ICAL,” on page 63 for register changes that
require an ICAL.
2
C (or SPI) port may not be accessed until 10 ms after RST_REG is asserted.
D5
Rev. 1.0
D4
Function
D3
Reserved
R
D2
D1
D0