1375961-2 TE Connectivity, 1375961-2 Datasheet - Page 5

• Manufacturer Part Number: 1375961-2
• Description: PC104 CONN NONSTKTHRGH 2 STDOF
• Manufacturer: TE Connectivity

Specifications of 1375961-2

• Rohs Compliant: NO
• Product Type: Non-Stackthrough
• Termination Style: Screw
• Housing Material: Nylon, Glass Filled
• Contact Material: Phosphor Bronze
• Contact Plating: Gold
• Number Of Standoffs: 2
• Pitch: 2.54 mm
• Keyed: No
• Pcb Mount Style: Through Hole
• Board Standoff: With
• Screw Material: Steel
• Gender: Receptacle
• Screw Plating: Zinc Chromate
• Signal Contact Current (a): 3
• Insulation Resistance (m?): 1,000
• Dielectric Withstanding Voltage (v): 500
• Termination Post Length (mm [in]): 3.02 [0.119]
• Number Of Positions: 104
• Number Of Loaded Positions: 104
• Centerline (mm [in]): 2.54 [0.100]
• Pcb Mount Retention Type: None
• Contact Configuration: Non-Stackthrough
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold
• Housing Color: Black
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: Not ELV/RoHS compliant
• Lead Free Solder Processes: Wave solder capable to 240°C
• Temperature Range (°c): -55 – +105
• Lead Free Status / Rohs Status: No

4.
4.1.
4.2.
4.3.
4.4.
Rev C
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specimens resubmitted for qualification. Testing to
confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. All test groups shall each consist of a minimum of 5
specimens.
Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figure 2.
108-1956
5 of 6