CS4351-CZZ Cirrus Logic Inc, CS4351-CZZ Datasheet - Page 20

• Manufacturer Part Number: CS4351-CZZ
• Description: IC DAC STER 112DB 192KHZ 20TSSOP
• Manufacturer: Cirrus Logic Inc

Specifications of CS4351-CZZ

• Package / Case: 20-TSSOP
• Number Of Bits: 24
• Data Interface: Serial
• Number Of Converters: 2
• Voltage Supply Source: Analog and Digital
• Power Dissipation (max): 354mW
• Operating Temperature: -10°C ~ 70°C
• Mounting Type: Surface Mount
• Conversion Rate: 192 KSPS
• Resolution: 24 bit
• Interface Type: Serial
• Operating Supply Voltage: 3.3 V/12 V
• Operating Temperature Range: + 70 C
• Maximum Power Dissipation: 354 mW
• Mounting Style: SMD/SMT
• Number Of Dac Outputs: 2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1152 - BOARD EVAL FOR CS4351 DAC
• Settling Time: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 598-1055-5

20
4.9
4.9.1
4.9.2
Control Port Interface
The control port is used to load all the internal register settings (see
port may be completely asynchronous with the audio sample rate. However, to avoid potential interference
problems, the control port pins should remain static if no operation is required.
The control port operates in one of two modes: I²C or SPI.
4.9.2.1
To write to the device, follow the procedure below while adhering to the control port Switching Specifica-
tions in
MAP Auto Increment
The device has MAP (memory address pointer) auto increment capability enabled by the INCR bit (also
the MSB) of the MAP. If INCR is set to 0, MAP will stay constant for successive I²C writes or reads and
SPI writes. If INCR is set to 1, MAP will auto increment after each byte is written, allowing block reads or
writes of successive registers.
I²C Mode
In the I²C mode, data is clocked into and out of the bi-directional serial control data line, SDA, by the serial
control port clock, SCL (see
ables the user to alter the chip address (100110[AD0][R/W]) and should be tied to VL or GND as required,
before powering up the device. If the device ever detects a high to low transition on the AD0/CS pin after
power-up, SPI mode will be selected.
1. Initiate a START condition to the I²C bus followed by the address byte. The upper 6 bits must be
2. Wait for an acknowledge (ACK) from the part, then write to the memory address pointer, MAP. This
3. Wait for an acknowledge (ACK) from the part, then write the desired data to the register pointed to
4. If the INCR bit (see
5. If the INCR bit is set to 0 and further I²C writes to other registers are desired, it is necessary to initiate
100110. The seventh bit must match the setting of the AD0 pin, and the eighth must be 0. The eighth
bit of the address byte is the R/W bit.
byte points to the register to be written.
by the MAP.
are written, then initiate a STOP condition to the bus.
a repeated START condition and follow the procedure detailed from step 1. If no further writes to oth-
er registers are desired, initiate a STOP condition to the bus.
Section
I²C Write
8.
Section
Figure 9
4.9.1) is set to 1, repeat the previous step until all the desired registers
for the clock to data relationship). There is no CS pin. Pin AD0 en-
Section
6). The operation of the control
CS4351
DS566F1