CS4361-CZZ Cirrus Logic Inc, CS4361-CZZ Datasheet - Page 21

• Manufacturer Part Number: CS4361-CZZ
• Description: IC DAC STER 6CH 103DB 20TSSOP
• Manufacturer: Cirrus Logic Inc

Specifications of CS4361-CZZ

• Package / Case: 20-TSSOP
• Number Of Bits: 24
• Data Interface: Serial
• Number Of Converters: 6
• Voltage Supply Source: Single Supply
• Power Dissipation (max): 455mW
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Conversion Rate: 192 KSPS
• Resolution: 24 bit
• Interface Type: Serial
• Operating Supply Voltage: 3.3 V or 5 V
• Operating Temperature Range: + 85 C
• Maximum Power Dissipation: 455 mW
• Mounting Style: SMD/SMT
• Number Of Dac Outputs: 6
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1153 - BOARD EVAL FOR CS4361428-1454 - SOCKET ADAPTER FOR CY2077FZ
• Settling Time: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 598-1057-5

6. PARAMETER DEFINITIONS
Total Harmonic Distortion + Noise (THD+N)
Dynamic Range
Interchannel Isolation
Interchannel Gain Mismatch
Gain Error
Gain Drift
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels.
The ratio of the full-scale rms value of the signal to the rms sum of all other spectral components over the
specified bandwidth. Dynamic range is a signal-to-noise measurement over the specified bandwidth made
with a -60 dBFS signal. 60 dB is then added to the resulting measurement to refer the measurement to full
scale. This technique ensures that the distortion components are below the noise level and do not effect the
measurement. This measurement technique has been accepted by the Audio Engineering Society, AES17-
1991, and the Electronic Industries Association of Japan, EIAJ CP-307.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with all zeros to the input under test and a full-scale signal applied to the other channel. Units in deci-
bels.
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal full scale analog output for a full scale digital input.
The change in gain value with temperature. Units in ppm/°C.
Confidential Draft
2/12/08
CS4361
21