LS037V7DW01 Sharp Electronics, LS037V7DW01 Datasheet - Page 20

• Manufacturer Part Number: LS037V7DW01
• Manufacturer: Sharp Electronics

Specifications of LS037V7DW01

• Lead Free Status / Rohs Status: Compliant

(14)Handling Precautions
14-3) Installation of the module
14-4)Precaution when mounting
14-5)Others
14-1) Insertion and taking out of FPCs
14-2) Handling of FPCs
(1) Be sure insert and take out of the FPC into the connector of the set after turning off the power supply
(1) The FPC for LCD panel shall be bent only slit portion. The bending slit shall be bent uniformly
(2) Don’t give the FPCs too large force, for example, hanging the module with holding FPC. Moreover,
(1) On mounting the module, be sure to fix the module on the same plane. Taking care not to warp or twist
(1) If water droplets and oil attaches to it for a long time, discoloration and staining occurs. Wipe them off
(2) Glass is used for the TFT-LCD panel or touch panel. If it is dropped or bumped against a hard object, it
(3) As the CMOS IC is used in this module, pay attention to static electricity when handling it. Take a
(1) The liquid-crystal is deteriorated by ultraviolet rays. Do not leave it in direct sunlight and
(2) If it is kept at a temperature below the rated storage temperature, it becomes coagulated and
(3) If the LCD breaks, don’t put internal liquid crystal into the mouth. When the liquid crystal sticks to the
(4) Wipe off water drop or finger grease immediately. Long contact with water may cause discoloration or
(5) Observe general precautions for all electronic components.
(6) Static image should not be displayed more than 5 minutes in order to prevent from occurrence of
on the set side.
on the whole slit portion with bending radius larger than 1.0mm ,and only inner side (back side of the
module). Don’t bend it outer side (display surface side).
Do not put stress on the components mounted on FPC to avoid failure of the components.
the module.
immediately.
may be broken. Handle it with sufficient care.
measure for grounding on the human body.
strong ultraviolet rays for many hours.
the panel may be broken. Also, if it is kept at a temperature above the rated storage temperature,
it becomes isotropic liquid and does not return to its original state. Therefore, it is desirable to keep it
at room temperature as much as possible.
hands, feet and clothes, wash it out immediately.
spots.
residual image.
LCP-06008A-17