LQ200T3LZ18 Sharp Electronics, LQ200T3LZ18 Datasheet - Page 20

• Manufacturer Part Number: LQ200T3LZ18
• Manufacturer: Sharp Electronics

Specifications of LQ200T3LZ18

• Lead Free Status / Rohs Status: Supplier Unconfirmed

10. Display Quality
11. Handling Precautions of the module
The display quality of the color TFT-LCD module shall be compliance with the incoming inspection standard
a) Be sure to turn off the power supply when inserting or disconnecting the cable.
b) This product is using the parts (inverter, CCFT etc), which generate the high voltage.
c) Brightness control voltage is switched for “ON” and “OFF”, as shown in Fig.4. Voltage difference generated
d) Be sure to design the cabinet so that the module can be installed without any extra stress such as warp or
e) Screw on a mounting hole in the module side surely.
f) Since the front polarizer is easily damaged, pay attention not to scratch it.
g) Since long contact with water may cause discoloration or spots, wipe off water drop immediately.
h) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
i) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface. Handle with
j) Since CMOS LSI is used in this module, take care of static electricity and take the human earth into
k) The module has some printed circuit boards (PCBs) on the back side, take care to keep them form any stress
l)
m) When some pressure is added onto the module from rear side constantly, it causes display non-uniformity
Therefore, during operating, please don't touch these parts.
*Since inverter board’s GND is not connected to the frame of the LCD module, please connect it with the
by this switching, ΔV
inverter and its surrounding circuit. So, separate the power supply of the inverter circuit with the one of its
surrounding circuit.
twist.
care.
consideration when handling.
or pressure when handling or installing the module; otherwise some of electronic parts on the PCBs may be
damaged.
issue, functional defect, etc.. So, please avoid such design.
Customer’s GND of inverter power supply.
Observe all other precautionary requirements in handling components.
BL,
may affect a sound output, etc. when the power supply is shared between the
Fig.4 Brightness control voltage.