B6TS16LFDEFAULT Omron, B6TS16LFDEFAULT Datasheet - Page 3

• Manufacturer Part Number: B6TS16LFDEFAULT
• Manufacturer: Omron

Specifications of B6TS16LFDEFAULT

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Example circuit - B6TS-04LT
Note 1:
Note 2:
Note 3:
19
20
Text
Capacitive Touch Sensing ICs - B6TS
1029
Pin
No.
___
OUT0
CHG
___
OUT1
___
SCS
Connect Rr, Cr, Rc, and Cc to each touch electrode, as shown in the above figure.
Refer to the design tool (B6TWorkbench) for their actual values.
Connect a bypass capacitor of about 0.1 µF between V
Connect a bypass capacitor of about 0.01 µF between /SETUP and Vss.
Desig-
nation
O
I/O
Rr0–7: Protective resistors
Cr0–7: Capacitors for comparison
Rc0–3: Resistors for charge control
Cc0–3: Charge capacitors
Output
Input/
Output pin to indicate operation.
[Normal measurement mode] outputs measured results.
[On/off output mode] channel 0 output (active low)
[Serial communication mode] output of measurement finish.
Two output modes are available in serial communication mode:
[Setup mode] When the setup mode is entered, CHG pin changes to high. However, when an
EEPROM write command is received and data is being written into EEPROM, this pin is low.
Output pin for measured result
[On/off output mode] channel 1 output (active low)
[Serial communication mode] serial communication chip select input
1. High-signal outputs every time a measurement finishes.
2. High-signal outputs when the condition changes in any one of the channels (touch
touch, no touch
→
touch).
DD
and Vss using as short wires as possible.
Function
→
no