170362-1 TE Connectivity, 170362-1 Datasheet - Page 3

• Manufacturer Part Number: 170362-1
• Description: UNIV M-N-L SOC. 22-18 AWG
• Manufacturer: TE Connectivity

Specifications of 170362-1

• Product Type: Contacts
• Contact Gender: Socket (Female)
• Voltage Rating: 600 V
• Current Rating: 9.5 A
• Mounting Style: Snap In
• Termination Style: Quick Connect
• Contact Plating: Pre Tin
• Contact Material: Brass
• Wire Gauge Range: 22-18
• Connector Line: Mini-Universal MATE-N-LOK
• Wire Insulation Diameter (mm [in]): 1.50 – 2.40 [0.059 – 0.094], 3.38 [0.133]
• Voltage (vac): 600
• Current Rating (a): 9.5
• Termination Method: Crimp
• Solder Tail Contact Plating: Pre-Tin
• Wire Range (mm [awg]): 0.30-0.90² [22-18], (2) 0.30-0.40² [(2) 22]
• Contact Diameter (mm [in]): 0.99 [0.039]
• Stock Thickness (mm [in]): 0.25 [0.010]
• Contact Type: Socket
• Contact Termination Type: Crimp
• Contact Base Material: Brass
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Wire/Cable
• Packaging Method: Strip
• Lead Free Status / Rohs Status: Details

3.5.5
3.5.6
3.5.7
3.5.8
Rev G
Temperature Rise Vs
Current
Vibration
(Low Frequency)
Physical Shock
Hammering Shock
30 C Max. under specified
current load.
No electrical discontinuity
greater than 1 µsec. shall occur.
TR: 60 m  M ax. (Final)
No electrical discontinuity
greater than 1µsec. shall occur.
TR: 60 m  M ax. (Final)
No evidence of abnormalities.
TR: 60 m  M ax. (Final)
Mechanical
Contacts series-wired, apply
test current of 1A DC to the
circuit, and measure the
temperature rise by probing
on soldered areas of
contacts, after the
temperature become
stabilized. Deduct ambient
temperature from the
measured value. Refer Fig.
3.
Tyco Spec 109-45-1
Subject mated connectors to
sinusoidal 10-55-10 Hz
traversed in 1 minute at 1.52
mm amplitude, 2 hours in
each of 3 mutually
perpendicular planes. Each
terminal shall be connected
in series and then 100 mA
DC shall be applied.
Refer Fig 4. Tyco Spec 109-
21-1.
Subject mated connectors to
50G’s halfsine shock pulses
of 11 milisecond duration; 3
shocks in each direction
applied along the 3 mutually
perpendicular planes. Total
18 shocks. 100 mA applied
current. Refer Fig 4.
Tyco Spec 109-26-1,
Condition A.
Subject mated connectors in
layout as shown in Fig 5 to
10,000 cycles of repeated
hammering shocks, with test
current of 1mA at 10V DC
applied to the circuit as
shown in Fig. 6.
During the test, the circuit
shall be monitored for
fluctuation of electrical
resistance.
108-51021
3 of 10