20-101-1028 Rabbit Semiconductor, 20-101-1028 Datasheet - Page 38

• Manufacturer Part Number: 20-101-1028
• Description: MODULE RABBITCORE RCM3750
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1028

• Module/board Type: MPU Core Module
• Product: Microcontroller Modules
• Core Processor: Rabbit 3000
• Flash: 512 KBytes
• Operating Supply Voltage: 4.75 to 5.25 V
• Board Size: 75 mm x 30 mm x 23 mm
• For Use With/related Products: RCM3750
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1110

4.4 Other Hardware
4.4.1 Clock Doubler
The RCM3750 takes advantage of the Rabbit 3000 microprocessor’s internal clock dou-
bler. A built-in clock doubler allows half-frequency crystals to be used to reduce radiated
emissions. The 22.1 MHz frequency specified for the RCM3750 is generated using a
11.06 MHz resonator.
The clock doubler may be disabled if 22.1 MHz clock speeds are not required. This will
reduce power consumption and further reduce radiated emissions. The clock doubler is
disabled with a simple configuration macro as shown below.
4.4.2 Spectrum Spreader
The Rabbit 3000 features a spectrum spreader, which helps to mitigate EMI problems. By
default, the spectrum spreader is on automatically, but it may also be turned off or set to a
stronger setting. The means for doing so is through a simple configuration macro as shown
below.
32
1. Select the “Defines” tab from the Dynamic C
2. Add the line
3. Click
1. Select the “Defines” tab from the Dynamic C
2. Normal spreading is the default, and usually no entry is needed. If you need to specify
3. Click
The clock doubler is enabled by default, and usually no entry is needed. If you need to
specify that the clock doubler is always enabled, add the line
always enable the clock doubler.
in the project file where you defined the macro.
normal spreading, add the line
For strong spreading, add the line
To disable the spectrum spreader, add the line
are in the project file where you defined the macro.
ENABLE_SPREADER=1
ENABLE_SPREADER=2
ENABLE_SPREADER=0
NOTE: Refer to the Rabbit 3000 Microprocessor User’s Manual for more information
NOTE: The strong spectrum-spreading setting is not recommended since it may limit
OK
OK
on the spectrum-spreading setting and the maximum clock speed.
the maximum clock speed or the maximum baud rate. It is unlikely that the strong set-
ting will be used in a real application.
to save the macro. The spectrum spreader will now remain off whenever you
to save the macro. The clock doubler will now remain off whenever you are
CLOCK_DOUBLED=0
to always disable the clock doubler.
Options > Project Options
Options > Project Options
CLOCK_DOUBLED=1
RabbitCore RCM3750
menu.
menu.
to