20-101-1139 Rabbit Semiconductor, 20-101-1139 Datasheet - Page 15

• Manufacturer Part Number: 20-101-1139
• Description: RCM4310 RABBITCORE
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1139

• Module/board Type: MPU Core Module
• Product: Microcontroller Modules
• Data Bus Width: 8 bit
• Core Processor: Rabbit 4000
• Clock Speed: 58.98 MHz
• Interface Type: Ethernet
• Flash: 1 MByte
• Timers: 10 x 8 bit
• Operating Supply Voltage: 3.3 V
• Board Size: 72 mm x 47 mm x 21 mm
• For Use With/related Products: RCM4310
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1142

2.2.4 Step 4 — Connect Power
Once all the other connections have been made, you can connect power to the Prototyping
Board.
First, prepare the AC adapter for the country where it will be used by selecting the plug.
The RCM4300 Development Kit presently includes Canada/Japan/U.S., Australia/N.Z.,
U.K., and European style plugs. Snap in the top of the plug assembly into the slot at the
top of the AC adapter as shown in Figure 4, then press down on the spring-loaded clip
below the plug assembly to allow the plug assembly to click into place. Release the clip to
secure the plug assembly in the AC adapter.
Connect the AC adapter to 3-pin header J1 on the Prototyping Board as shown in Figure 4.
The connector may be attached either way as long as it is not offset to one side—the center
pin of J1 is always connected to the positive terminal, and either edge pin is ground.
Plug in the AC adapter. The
LED on the Prototyping Board next to the power con-
PWR
nector at J1 should light up. The RCM4300 and the Prototyping Board are now ready to be
used.
NOTE: A RESET button is provided on the Prototyping Board next to the battery holder
to allow a hardware reset without disconnecting power.
To power down the Prototyping Board, unplug the power connector from J1. You should
disconnect power before making any circuit adjustments in the prototyping area, changing
any connections to the board, or removing the RCM4300 from the Prototyping Board.
RabbitCore RCM4300 User’s Manual
15