101-0522 Rabbit Semiconductor, 101-0522 Datasheet - Page 15

• Manufacturer Part Number: 101-0522
• Description: MODULE RABBITCORE RCM3220
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0522

• Module/board Type: MPU Core Module
• For Use With/related Products: RCM3220
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 101-522; 101-522

2.3 Starting Dynamic C
Once the RCM3700 is connected as described in the preceding pages, start Dynamic C by
double-clicking on the Dynamic C icon on your desktop or in your
If you are using a USB port to connect your computer to the RCM3700, choose
Project Options
which COM port was assigned to the RS-232/USB converter. Click
2.4 Run a Sample Program
Use the
SAMPLES
window will open on your PC and will display a small square bouncing around in a box.
This program shows that the CPU is working.
2.4.1 Troubleshooting
If Dynamic C cannot find the target system (error message
Detected."
• Check that the RCM3700 is powered correctly —
• Check both ends of the programming cable to ensure that they are firmly plugged into
• Ensure that the RCM3700 module is firmly and correctly installed in its connectors on
• Dynamic C uses the COM port specified during installation. Select a different COM
RabbitCore RCM3700 User’s Manual
Board should be lit when the RCM3700 is mounted on the Prototyping Board and the AC
adapter is plugged in
the PC and the
ming port on the RCM3700 with the marked (colored) edge of the programming cable
towards pin 1 of the programming header.
the Prototyping Board.
port within Dynamic C. From the
Communications
<Ctrl-Y>
unable to locate the target system, repeat the above steps until you locate the COM port
used by the programming cable.
File
folder. Press function key
to force Dynamic C to recompile the BIOS. If Dynamic C still reports it is
menu to open the sample program
):
PROG
and select “Use USB to Serial Converter.” You may have to determine
. Select another COM port from the list, then click OK. Press
.
connector, not the
F9
Options
to compile and run the program. The
DIAG
menu, select
PONG.C
connector, is plugged in to the program-
the red power lamp on the Prototyping
, which is in the Dynamic C
"No Rabbit Processor
Project Options
Start
OK
.
menu.
, then select
STDIO
Options >
13