101-0522 Rabbit Semiconductor, 101-0522 Datasheet - Page 35

• Manufacturer Part Number: 101-0522
• Description: MODULE RABBITCORE RCM3220
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0522

• Module/board Type: MPU Core Module
• For Use With/related Products: RCM3220
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 101-522; 101-522

4.2.3 Serial Programming Port
The RCM3700 programming port is accessed through header J2 or over an Ethernet con-
nection via the RabbitLink EG2110. The programming port uses the Rabbit 3000’s Serial
Port A for communication. Dynamic C uses the programming port to download and debug
programs.
The programming port is also used for the following operations.
• Cold-boot the Rabbit 3000 on the RCM3700 after a reset.
• Remotely download and debug a program over an Ethernet connection using the
• Fast copy designated portions of flash memory from one Rabbit-based board (the
In addition to Serial Port A, the Rabbit 3000 startup-mode (SMODE0, SMODE1), status,
and reset pins are available on the programming port.
The two startup mode pins determine what happens after a reset—the Rabbit 3000 is
either cold-booted or the program begins executing at address 0x0000.
The status pin is used by Dynamic C to determine whether a Rabbit microprocessor is
present. The status output has three different programmable functions:
1. It can be driven low on the first op code fetch cycle.
2. It can be driven low during an interrupt acknowledge cycle.
3. It can also serve as a general-purpose CMOS output.
The /RESET_IN pin is an external input that is used to reset the Rabbit 3000 and the
RCM3700 onboard peripheral circuits. The serial programming port can be used to force a
hard reset on the RCM3700 by asserting the /RESET_IN signal.
Alternate Uses of the Programming Port
All three clocked Serial Port A signals are available as
• a synchronous serial port
• an asynchronous serial port, with the clock line usable as a general CMOS input
The programming port may also be used as a serial port once the application is running.
The SMODE pins may then be used as inputs and the status pin may be used as an output.
Refer to the
RabbitCore RCM3700 User’s Manual
RabbitLink EG2110.
master) to another (the slave) using the Rabbit Cloning Board.
Rabbit 3000 Microprocessor User’s Manual
for more information.
33