20-101-0654 Rabbit Semiconductor, 20-101-0654 Datasheet - Page 16

• Manufacturer Part Number: 20-101-0654
• Description: INTERFACE OP6800 512K FLASH&SRAM
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0654

• Module/board Type: Single Board Computer Module
• Product: Modules
• Processor Type: Rabbit 2000
• Sram: 128 KB
• Flash: 256 KB
• Timers: 8 bit, 10 bit
• Backup Battery: Lithium Battery
• Operating Voltage: 9 V to 36 V
• Power Consumption: 1.5 W
• Board Size: 111 mm x 91 mm x 33 mm
• Description/function: Computer Module
• For Use With/related Products: OP6800
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-654; 20-101-654

2.5 Installing Dynamic C
If you have not yet installed Dynamic C version 7.06P2 (or a later version), do so now by
inserting the Dynamic C CD in your PC’s CD-ROM drive. The CD will auto-install unless
you have disabled auto-install on your PC.
If the CD does not auto-install, click
browse for the Dynamic C
installation once you have selected the
The Dynamic C User’s Manual provides detailed instructions for the installation of
Dynamic C and any future upgrades.
2.6 Starting Dynamic C
Once the OP6800 is connected to your PC and to a power source, start Dynamic C by dou-
ble-clicking on the Dynamic C icon on your desktop or in your
If you are using a USB port to connect your computer to the OP6800, choose
Project Options
Dynamic C assumes, by default, that you are using serial port COM1 on your PC. If you
are using COM1, then Dynamic C should detect the OP6800 and go through a sequence of
steps to cold-boot the OP6800 and to compile the BIOS. If the error message “Rabbit Pro-
cessor Not Detected” appears, you have probably connected to a different PC serial port
such as COM2, COM3, or COM4. You can change the serial port used by Dynamic C with
the
Reset Target/Compile BIOS
OPTIONS
C to recognize the target on any port, then the hookup may be wrong or the COM port
might not working on your PC.
If you receive the “BIOS successfully compiled …” message after pressing
starting Dynamic C, and this message is followed by a communications error message, it
is possible that your PC cannot handle the 115,200 bps baud rate. Try changing the baud
rate to 57,600 bps as follows.
• Locate the
12
Communications
OPTIONS
NOTE: If you have an earlier version of Dynamic C already installed, the default instal-
lation of the later version will be in a different folder, and a separate icon will appear on
your desktop.
menu until you find the one you are connected to. If you still can’t get Dynamic
Serial Options
menu, then try to get Dynamic C to recognize the OP6800 by selecting
and select “Use USB to Serial Converter.” Click
menu. Change the baud rate to 57,600 bps.
setup.exe
dialog in the Dynamic C
on the
Start > Run
Compile
setup.exe
file on your CD drive. Click
menu. Try the different COM ports in the
from the Windows
file.
Options > Project Options >
Start
OK
OK
Start
menu.
.
to begin the
MiniCom (OP6800)
button and
<Ctrl-Y>
Options >
or