SYJ314-5MZ-M5 SMC Corporation, SYJ314-5MZ-M5 Datasheet - Page 58

• Manufacturer Part Number: SYJ314-5MZ-M5
• Description: Solenoid Valve; 3 port; normally closed; base mt; 24VDC; M plug conn w/.3 lead
• Manufacturer: SMC Corporation
• Type: Direct Operatedr

Specifications of SYJ314-5MZ-M5

• Brand/series: SY Series
• Configuration: 2-Position Single
• Number Of Ports: 3
• Primary Type: Solenoid Valve
• Voltage, Coil: 24 VDC

Connector assembly with dust proof protective cover.
• Effective to prevention of short circuit failure due to the entry of
• Chloroprene rubber for electrical use, which provides outstand-
• Simple and unencumbered appearance by adopting round-shaped
How to Order
Connector Assembly with Cover: Dimensions
How to Order
Enter the part number for a plug connector solenoid valve without
connector together with the part number for a connector assem-
bly with cover.
Ex. 1) Lead wire length of 2000 mm
Ex. 2) Lead wire length of 300 mm (standard)
∗ In this case, the part number for the connector assembly with
4-4-60
SY100 - 68 - A
foreign matter into the connector.
ing weather resistance and electrical insulation, is used for the
cover material. However, do not allow contact with cutting oil,
etc.
cord.
cover is not required.
Caution
SYJ312-5LOZ-M3
SY100-68-A-20
SYJ312-5LPZ-M3
(14.5)
Connector Assembly with Cover
(10)
Series
Specific Product Precautions 5
Be sure to read before handling.
Symbol for connector assembly with cover
Red
(40)
Nil
10
15
20
25
30
50
Lead wire length
6
SYJ300/500/700
Black
1000 mm
1500 mm
2000 mm
2500 mm
3000 mm
5000 mm
300 mm
600 mm
L
Gray
(8)
1. M8 connector types have an IP65 (enclosure) rating, offering
2. Do not use a tool to mount the connector, as this may cause
Failure to meet IP65 performance may result if using alternative
connectors than those shown above, or when insufficiently tight-
ened.
• Connector cable mounting
Note) Connector cable should be mounted in the correct
protection from dust and water. However please note: these
products are not intended for use in water.
Select a SMC connector cable (V100-49-1-„) or a FA sensor
type connector, with M8 threaded 3 pin specifications
conforming to Nippon Electric Control Equipment Association
Standard, NECA4202 (IEC60947-5-2). Make sure the
connector O.D. is 10.5 mm or less when used with the Series
SYJ300 manifold. If more than 10.5 mm, it cannot be mounted
due to the size.
damage. Only tighten by hand. (0.4 to 0.6 N·m)
Caution
Caution
direction. Make sure that the arrow symbol on the
connector is facing the triangle symbol on the valve
when using SMC connector cable (V100-49-1- ). Be
careful not to squeeze it in the wrong direction, as
problems such as pin damage may occur.
Arrow mark
Triangle mark
M8 Connector