NAV2000-N02-3DZ SMC Corporation, NAV2000-N02-3DZ Datasheet - Page 7

• Manufacturer Part Number: NAV2000-N02-3DZ
• Description: Valve; 1/4 in.; NPT; 1/4; 1 MPa; 1.5 MPa; 0 to degC; (N)AV 2000 Series
• Manufacturer: SMC Corporation

Specifications of NAV2000-N02-3DZ

• Body Size: 1⁄4
• Brand/series: (N)AV 2000 Series
• Dimensions: 66 mm L x 40 mm W x 125.5 H
• Pressure, Operating: 1 MPa
• Proof Pressure: 1.5 MPa
• Size, Port: 1⁄4
• Temperature, Ambient: 0 to +60 °C
• Thread Type: NPT
• Operating Pressure Range: 27 to 145 PSI
• Allowable Voltage Fluctuation: –15% to +10% of Rated Voltage
• Ambient And Fluid Temperature: 32°-140°F

7
These safety instructions are intended to prevent a hazardous situation and/or
equipment damage. These instructions indicate the level of potential hazard by a
label of "Caution", "Warning" or "Danger". To ensure safety, be sure to
observe ISO 4414
Note 1) ISO 4414 : Pneumatic fluid power -- Recommendations for the application of equipment to transmission and
Note 2) JIS B 8370 : General Rules for Pneumatic Equipment.
1.
2.
3.
4.
1. Inspection and maintenance of machinery/equipment should only be performed after confirmation of
2. When equipment is to be removed, confirm the safety process as mentioned above. Cut the supply
3. Before machinery/equipment is restarted, take measures to prevent shooting-out of cylinder piston rod,
1. Conditions and environments beyond the given specifications, or if product is used outdoors.
2. Installation on equipment in conjunction with atomic energy, railway, air navigation, vehicles, medical
3. An application which has the possibility of having negative effects on people, property, or animals,
who designs the pneumatic system or decides its specifications.
Since the products specified here are used in various operating conditions, their compatibility for the
specific pneumatic system must be based on specifications or after analysis and/or tests to meet your
specific requirements.
equipment.
Compressed air can be dangerous if an operator is unfamiliar with it. Assembly, handling or repair of
pneumatic systems should be performed by trained and experienced operators.
safety is confirmed.
safe locked-out control positions.
pressure for this equipment and exhaust all residual compressed air in the system.
etc. (Bleed air into the system gradually to create back pressure.)
equipment, food and beverages, recreation equipment, emergency stop circuits, press applications, or
safety equipment.
requiring special safety analysis.
The compatibility of pneumatic equipment is the responsibility of the person
Only trained personnel should operate pneumatically operated machinery and
Do not service machinery/equipment or attempt to remove components until
Contact SMC if the product is to be used in any of the following conditions:
Safety Instructions
Series
Caution:
Warning:
Danger:
control systems.
AV2000/3000/4000/5000
Note 1)
In extreme conditions, there is a possible result of serious injury or loss of life.
Operator error could result in injury or equipment damage.
Operator error could result in serious injury or loss of life.
, JIS B 8370
Warning
Note 2)
and other safety practices.