PSB3186HV14XP Lantiq, PSB3186HV14XP Datasheet - Page 27
![](/photos/31/31/313132/64pin_mqfp_sml.jpg)
PSB3186HV14XP
Manufacturer Part Number
PSB3186HV14XP
Description
Manufacturer
Lantiq
Datasheet
1.PSB3186HV14XP.pdf
(200 pages)
Specifications of PSB3186HV14XP
Number Of Line Interfaces
1
Control Interface
HDLC
Lead Free Status / Rohs Status
Compliant
- Current page: 27 of 200
- Download datasheet (4Mb)
3.2
The ISAC-SX TE supports a serial or a parallel microcontroller interface. For applications
where no controller is connected to the ISAC-SX TE microcontroller interface
programming is done via the IOM-2 MONITOR channel from a master device. In such
applications the ISAC-SX TE operates in the IOM-2 slave mode (refer to the
corresponding chapter of the IOM-2 MONITOR handler). This mode is suitable for
control functions (e.g. programming registers of the S/T transceiver), but the bandwidth
is not sufficient for access to the HDLC controllers.
The interface selections are all done by pinstrapping (see
are evaluated when the reset input RES is active. For the pin levels stated in the tables
the following is defined:
’High’, ’Low’: dynamic pin; value must be ’High’ or ’Low’ only during reset
V
edge:
Table 3
WR
(R/W)
’High’
V
Note: For a selected interface mode which doesn’t need all input selection and address
The interfaces contain all circuitry necessary for the access to programmable registers,
status registers and HDLC FIFOs. The mapping of all these registers can be found in
Chapter
The microcontroller interface also provides an interrupt request at pin INT which is low
active by default but can be reprogrammed to high active, a reset input pin RES and a
reset output pin RSTO.
The interrupt request pin INT becomes active if the ISAC-SX TE requests an interrupt
and this can occur at any time.
Data Sheet
DD
SS
, V
PINS
pins the unused pins must be tied to V
SS
RD
(DS)
’High’ Parallel
V
4.
:
SS
Microcontroller Interfaces
static pin; pin must statically be strapped to ’High’ or ’Low’ level
dynamic pin; any transition (’High’ to ’Low’, ’Low’ to ’High’) has occured
Host Interface Selection
Serial /Parallel
Interface
Serial
No
Host Interface
CS
‘High’ V
’High’ V
V
SS
PINS
ALE
V
edge
V
DD
SS
SS
SS
27
DD
or V
Interface
Type/Mode
Motorola
Siemens/Intel Non-Mux
Siemens/Intel Mux
Serial Control Interface(SCI)
IOM-2 MONITOR Channel
(Slave Mode)
Description of Functional Blocks
SS
.
Table
3). The selection pins
ISAC-SX TE
PSB 3186
2003-01-30
Related parts for PSB3186HV14XP
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![PSB31](/images/no-image3.png)
Part Number:
Description:
Single Phase Rectifier Bridges
Manufacturer:
POWERSEM [Powersem GmbH]
Datasheet:
![PEB22811H-V13X](/images/manufacturer_photos/0/3/379/lantiq_tmb.jpg)
Part Number:
Description:
Manufacturer:
Lantiq
Datasheet:
![ADM6996L-AA-T-1](/images/manufacturer_photos/0/3/379/lantiq_tmb.jpg)
Part Number:
Description:
Manufacturer:
Lantiq
Datasheet: