11-4945-225-00 3M, 11-4945-225-00 Datasheet - Page 13

• Manufacturer Part Number: 11-4945-225-00
• Description: LCD Touch Panels 17 C1700SS USB, No Bezel
• Manufacturer: 3M
• Series: C1700SSr
• Type: Capacitiver

Specifications of 11-4945-225-00

• Length: 13" (337.9mm)
• Width: 16" (405mm)
• Height: 10.6" (270.3mm)
• Interface: USB
• Diagonal Screen Size: 17" (433mm)
• Lead Free Status / Rohs Status: Details

3M™ MicroTouch™ Display C1700SS Installation Guide
Access to the Video Controls
Clearance and Ventilation
Securing and Routing System Cables
Installing the Video Card and Video Driver
Supported Video Display Modes and Refresh Rates
The controls for adjusting the video display are located on the back of the C1700SS
Display. These buttons let you display the on-screen menu and adjust the phase, image
position, contrast, and brightness. Make sure you will be able to access the video
controls once the C1700SS Display is installed.
Leave at least two inches of clearance space behind the C1700SS Display for proper
ventilation. Units have vent holes at the top and bottom on the back of the chassis --
ensure these holes are not blocked during installation. Always maintain adequate
ventilation to protect the display from overheating and to ensure reliable and continued
operation. Refer to the published specifications for the maximum and minimum operating
temperature and humidity conditions.
You must be sure to secure all cable connections. Shaking and vibration, especially
during shipment, may dislodge components that are improperly connected.
• Be sure to tighten all cable screws.
• Route all wiring and cabling away from heat sources and sharp metal edges to avoid
Before you can connect your touch display, make sure your computer has a video card
already installed for the display. After you connect the display, you need to install the
video software driver. The video driver is supplied by the video card manufacturer and
may be found on the diskettes that came with your computer. If you need information on
installing a video card or video driver, refer to the manual that came with your video
card.
Your video card must support one of the display modes specified in Table 1. If you
select an unsupported video mode, the display will stop working or display an
unsatisfactory picture quality.
damage. Also, keep the touch sensor cable away from sources of electromagnetic and
radio frequency interference.
3M Touch Systems Proprietary Information
13