LM3481QMM/NOPB National Semiconductor, LM3481QMM/NOPB Datasheet - Page 8

• Manufacturer Part Number: LM3481QMM/NOPB
• Description: Low Side NFET Controller
• Manufacturer: National Semiconductor
• Series: -r

Specifications of LM3481QMM/NOPB

• Pwm Type: Current Mode
• Number Of Outputs: 1
• Frequency - Max: 1MHz
• Duty Cycle: 85%
• Voltage - Supply: 2.97 V ~ 48 V
• Buck: No
• Boost: Yes
• Flyback: Yes
• Inverting: No
• Doubler: No
• Divider: No
• Cuk: No
• Isolated: No
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 10-TFSOP, 10-MSOP (0.118", 3.00mm Width)
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

www.national.com
Functional Block Diagram
Functional Description
The LM3481 uses a fixed frequency, Pulse Width Modulated
(PWM), current mode control architecture. In a typical appli-
cation circuit, the peak current through the external MOSFET
is sensed through an external sense resistor. The voltage
across this resistor is fed into the I
level shifted and fed into the positive input of the PWM com-
parator. The output voltage is also sensed through an external
feedback resistor divider network and fed into the error am-
plifier (EA) negative input (feedback pin, FB). The output of
the error amplifier (COMP pin) is added to the slope compen-
sation ramp and fed into the negative input of the PWM
comparator.
At the start of any switching cycle, the oscillator sets the RS
latch using the SET/Blank-out and switch logic blocks. This
forces a high signal on the DR pin (gate of the external MOS-
FET) and the external MOSFET turns on. When the voltage
on the positive input of the PWM comparator exceeds the
negative input, the RS latch is reset and the external MOSFET
turns off.
SEN
pin. This voltage is then
8
The voltage sensed across the sense resistor generally con-
tains spurious noise spikes, as shown in
spikes can force the PWM comparator to reset the RS latch
prematurely. To prevent these spikes from resetting the latch,
a blank-out circuit inside the IC prevents the PWM comparator
from resetting the latch for a short duration after the latch is
set. This duration, called the blank-out time, is typically 250
ns and is specified as t
section.
Under extremely light load or no-load conditions, the energy
delivered to the output capacitor when the external MOSFET
is on during the blank-out time is more than what is delivered
to the load. An over-voltage comparator inside the LM3481
prevents the output voltage from rising under these conditions
by sensing the feedback (FB pin) voltage and resetting the
RS latch. The latch remains in a reset state until the output
decays to the nominal value. Thus the operating frequency
decreases at light loads, resulting in excellent efficiency.
min
(on) in the electrical characteristics
Figure
20136506
1. These