M25PX64-VMF6P NUMONYX, M25PX64-VMF6P Datasheet - Page 51

• Manufacturer Part Number: M25PX64-VMF6P
• Description: 64MB NOR FLASH
• Manufacturer: NUMONYX

6.18
Deep power-down (DP)
Executing the deep power-down (DP) instruction is the only way to put the device in the
lowest consumption mode (the deep power-down mode). It can also be used as a software
protection mechanism, while the device is not in active use, as in this mode, the device
ignores all write, program and erase instructions.
Driving Chip Select (S) High deselects the device, and puts the device in the standby power
mode (if there is no internal cycle currently in progress). But this mode is not the deep
power-down mode. The deep power-down mode can only be entered by executing the deep
power-down (DP) instruction, subsequently reducing the standby current (from I
as specified in
To take the device out of deep power-down mode, the release from deep power-down
(RDP) instruction must be issued. No other instruction must be issued while the device is in
deep power-down mode.
The deep power-down mode automatically stops at power-down, and the device always
powers up in the standby power mode.
The deep power-down (DP) instruction is entered by driving Chip Select (S) Low, followed
by the instruction code on serial data input (DQ0). Chip Select (S) must be driven Low for
the entire duration of the sequence.
The instruction sequence is shown in
Chip Select (S) must be driven High after the eighth bit of the instruction code has been
latched in, otherwise the deep power-down (DP) instruction is not executed. As soon as
Chip Select (S) is driven High, it requires a delay of t
to I
Any deep power-down (DP) instruction, while an erase, program or write cycle is in
progress, is rejected without having any effects on the cycle that is in progress.
Figure 27. Deep power-down (DP) instruction sequence
S
C
DQ0
CC2
and the deep power-down mode is entered.
Table
0
17).
1
2
Instruction
3
4
5
6
Figure
7
27.
DP
before the supply current is reduced
t
Standby mode
DP
Deep power-down mode
CC1
to I
AI13744
51/70
CC2
,