XW2Z-200J-B10 Omron, XW2Z-200J-B10 Datasheet - Page 32

• Manufacturer Part Number: XW2Z-200J-B10
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B10

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB10

1-5
1-5-1
System Configuration
1-5-2
Protocols
Expanded System Configuration
Host Link (SYS-
MAC WAY)
No-protocol (cus-
tom) communica-
tions
NT Links (1: N)
Peripheral Bus
(Toolbus)
Serial PLC Link
Slave
Serial Gateway
Protocol
Expanded System Configuration
Serial Communications
Systems
Personal computer
OMRON Programmable Termi-
nals (PTs)
General-purpose external devices
Servo Drivers
Host controllers
OMRON Programmable Termi-
nals (PTs)
CX-Programmer
OMRON PLC
OMRON Programmable Termi-
nals (PTs)
Servo Drivers
Main connection
The FQM1 system can be expanded using the two serial ports built into the
Coordinator Module: Peripheral port and RS-232C port.
The serial communications port mode (protocol) can be switched in the Coor-
dinator Module’s System Setup. Depending on the protocol selected, the fol-
lowing systems can be configured.
The following protocols support serial communications.
Host Link
Host computer
RS-232C port
Peripheral
port
Communications between the
host computer and the Module
No-protocol communications with
general-purpose devices, host
controllers, and Servo Drivers
High-speed communications with
Programmable Terminals via
direct access
Communications between the
CX-Programmer running on a
computer and the FQM1
Communications between
OMRON PLC and the FQM1
Communications between a PT
and W-series or SMARTSTEP
Servo Drivers via the FQM1
CX-Programmer
Coordinator Module
Automatic detection of
communications parameters
Use
Host Link commands/ FINS
commands
TXD(236) instruction and
RXD(235) instruction
None
None
None
FINS commands
Applicable commands and
communications
instructions
Section 1-5
9