QT115A-ISG Atmel, QT115A-ISG Datasheet - Page 56

• Manufacturer Part Number: QT115A-ISG
• Description: IC TOUCH SENSOR PROX 8SOIC
• Manufacturer: Atmel

Specifications of QT115A-ISG

• Input Type: *
• Output Type: *
• Interface: *
• Current - Supply: *
• Mounting Type: Surface Mount
• Operating Supply Voltage: 3 V to 5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SO-8
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Package / Case: -
• Lead Free Status / Rohs Status: Details

10620D–AT42–04/09
Mutual-capacitance One-dimensional Sensors
6.3
6.3.1
6.3.2
6.3.2.1
6-2
Typical Spatially Interpolated Method
Introduction
One-Layer Small Slider Or Wheel
Slider
This method uses an array of keys directly adjacent to each other.
There are numerous ways to construct a spatially interpolated slider, but the most basic form is to use an
array of keys as shown in
n x 6 mm to n x 8 mm in length, where n is the number of keys used. For larger sliders use a resistively
interpolated design (see
From
and Y fingers for design purposes. There is no border between the keys, only at either end of the slider.
Instead, an "extra" Y finger is inserted between each key.
Note:
Figure 6-1.
Given the widths of the Y and X traces, you will need to calculate the number of X fingers (X
will fit in the slider, allowing for end borders of at least T wide. Any unallocated width remaining after the
number of fingers has been calculated is added to the end of the slider, so the width of the end borders
(X
X
border
border
Y
(Typically
0.1–0.5 mm)*
width
Figure 6-1
T/2
T/2
³
) must also be calculated.
T
This method by its nature has the electrodes arranged on a single layer, which means that Y
electrode cuts through the X electrodes. Jumpers or vias are therefore required to connect the
isolated X regions to the interdigitated X regions.
One-layer Small Slider (Spatially Interpolated)
it can be seen that the slider can be treated as one large “super key” of interdigitated X
X3
Section 6.4 “Typical Resistively Interpolated Method” on page 6-10
Between Xs
Y
Figure 6-1 on page
T/2
width
Gap
W (6–8 mm)
X2
X electrodes require a
jumper or via to connect
the
6-2. It is suitable for sliders that are approximately
two isolated X regions
L
.
X1
Touch Sensors Design Guide
T
X0
T/2
).
fingers
5 50 mm
–
) that