CC-9P-V526UJ-EA Digi International, CC-9P-V526UJ-EA Datasheet - Page 59

• Manufacturer Part Number: CC-9P-V526UJ-EA
• Description: MOD 9P 9215 CONNCORE 8MB FLASH
• Manufacturer: Digi International
• Series: -r

Specifications of CC-9P-V526UJ-EA

• Module/board Type: Core Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Networking

Serial port C TTL
interface
59
1
2
3
4
5
6
7
8
9
10
Pin
DCDC#/TXCLKC
DSRC#
RXDC#
RTSC#/RXCLKC
TXDC
CTSC#
DTRC#/TXCLKC
RIC#/RXCLKC/GPIO 12
GND
3.3V
Function
ConnectCore 9P 9215, Wi-9P 9215, and 3G 9P 9215 Hardware Reference
The serial (UART) port C interface is a TTL interface connected to a 2x5 pin, 0.1”
connector, X5. The connector supports only TTL level.
The serial port C interface corresponds to the NS9215 UART port C. The signals are
shared with the
Serial port C pins are allocated as shown:
Note: Port C is not available on the ConnectCore 3G 9P 9215.
By using GPIO12 as RIC#, be sure to populate a series resistor on the baseboard. This
is necessary to avoid conflict between the default configuration of the GPIO when
booting (RESET_DONE / output) and the chosen configuration once booted (RIC# /
input).
By default, Serial C signals are configured to their respective GPIO signals, except
for GPIO12. It is the responsibility of the driver to configure them properly.
GPIO8.
GPIO10.
GPIO11
GPIO13
GPIO15
GPIO9
GPIO14
RESET_DONE See note
Defaults to
HDLC
interface.
CC3G: RXDC# internally used
CC3G: TXCLKC internally used
Comments