LM5117PMH/NOPB National Semiconductor, LM5117PMH/NOPB Datasheet - Page 16

• Manufacturer Part Number: LM5117PMH/NOPB
• Description: IC BUCK CONTROLLER 20-TSSOP
• Manufacturer: National Semiconductor
• Series: -r

Specifications of LM5117PMH/NOPB

• Pwm Type: Current Mode
• Number Of Outputs: 1
• Frequency - Max: 530kHz
• Duty Cycle: 95%
• Voltage - Supply: 5.5 V ~ 65 V
• Buck: Yes
• Boost: No
• Flyback: No
• Inverting: No
• Doubler: No
• Divider: No
• Cuk: No
• Isolated: No
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 20-TSSOP (0.173", 4.40mm Width) Exposed Pad
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

www.national.com
During an output short condition, the worst case peak inductor
current is limited to:
Where t
If the saturation current of the inductor is less than I
peak inductor current during output short condition may be
higher than I
and inductor should be checked under this condition.
Hiccup Mode Current Limiting
To further protect the regulator during prolonged current limit
conditions, LM5117 provides a hiccup mode current limit. An
internal hiccup mode fault timer counts the PWM clock cycles
during which cycle-by-cycle current limiting occurs. When the
hiccup mode fault timer detects 256 consecutive cycles of
current limiting, an internal restart timer forces the controller
to enter a low power dissipation standby mode and starts
sourcing 10μA current into the RES pin capacitor C
standby mode, HO and LO outputs are disabled and the soft-
start capacitor C
C
time (t
automatically restarting. When the RES pin voltage exceeds
the 1.25V RES threshold, RES capacitor is discharged and a
soft-start sequence begins. t
following equation:
RES
is connected from RES pin to AGND and determines the
RES
ON(MIN)
) in which the LM5117 remains in the standby before
LIM_PK
FIGURE 10. Inductor Current
is the minimum HO on-time.
SS
. The temperatures of NMOS devices, Rs
is discharged.
RES
can be calculated from the
FIGURE 13. RES Configurations
RES
LIM_PK
30143215
. In this
, the
(12)
(13)
16
The RES pin can also be configured for latch-off mode current
limiting or non-hiccup mode cycle-by-cycle current limiting. If
the RES pin is tied to VCC or a voltage greater than the RES
threshold at initial power-on, the restart timer is disabled and
the regulator operates with non-hiccup mode cycle-by-cycle
current limit. If the RES pin is tied to GND, the regulator enters
into the standby mode after 256 consecutive cycles of current
limiting and then never restarts until UVLO shutdown is cy-
cled. The restart timer is configured during initial power-on
when UVLO is above the UVLO threshold and VCC is above
the VCC UV threshold.
FIGURE 11. Hiccup Mode Current Limit Timing Diagram
FIGURE 12. Hiccup Mode Current Limit Circuit
30143220
30143218
30143219