HW1M-LF1010-20 IDEC, HW1M-LF1010-20 Datasheet - Page 50
![18M7189](/photos/40/47/404725/4783430_sml.jpg)
HW1M-LF1010-20
Manufacturer Part Number
HW1M-LF1010-20
Description
18M7189
Manufacturer
IDEC
Datasheet
1.HW1M-LF0101-20.pdf
(51 pages)
Mounting Hole Layout
Applicable Terminal
Nameplate
The nameplate is supplied with the pushbutton and selector
switch control boxes. When not using the nameplate, use
the cover gasket (HW9Z-W).
HW series nameplates (HWA∗) cannot be used.
Operating Instructions
• Panel Mounting
To mount the control box on a panel, use two M4 screws,
plane washers and spring washers to preventing loosening.
Tighten the screws to a torque of 1.4 to 2.0 N·m.
Determine the screw length in consideration of the panel
thickness.
50
Type No.
Color: Black, without legend
Thickness: 1.2 mm
(Remove the anti-rotation projection)
Material
ø22
4 max.
HW
ø3.6 min.
5.5 min.
Series
M4 Screw
Control Box
Tightening torque: 1.0 to 1.3 N·m
A maximum of two pieces can be
connected to one terminal.
2-ø4.6
Control Boxes
58
Panel
3
Plain Washer
Spring Washer
Hexagonal Nut
Aluminum
NSA-0
34
• Applicable Connector and Installation
1. To install a connector, break open the conduit port on the
2. Use G1/2 or PG16 connectors which can mount on a
3. Only when using a plastic connector, Insulation Class II
4. Install the box cover flat on the box base. When the box
• Applicable Cables
• Applicable Conduits
Wire containment density: 32% to 48%
Select a cable appropriate for the connector.
Metal Conduit Outside Diameter
Conduit Inside Diameter
IV Wire Quantity
Applicable CVV Cable
top and bottom of the control box. Before opening the
conduit port, remove the attached two connector locking
nuts from the control box base. Place the tip of a screw-
driver on the conduit port and strike the screwdriver end.
Make sure that the conduit port is free from burs and
cracks, which may hamper waterproof characteristics.
panel of 4.0 mm thick minimum. To install the connector
to the control box, use the attached connector locking nut
and tighten the locking nut sufficiently. If the locking nut is
tightened insufficiently, the waterproof characteristics are
not ensured.
(IEC 61140) is satisfied.
cover is installed diagonally, the box cover cannot be
secured correctly, resulting in an operation error.
Thread Size
Locking Nut for
Installing Connector
(supplied with control box)
1.25 mm
PG16
G1/2
2.0 mm
2
2
Locking Nut Color
1.25 mm
2.0 mm
ø14.5 mm maximum
ø14.5 mm maximum
White
Black
Outside Diameter
2
2
4
Screwdriver
minimum
ø8.3 mm
ø10 mm
2 to 3
2 to 3
Locking Nut Type No.
HW9Z-PG
HW9Z-G
Core Wires
8 maximum
8 maximum
ø10.6 mm
minimum
ø12 mm
4 to 6
3 to 4