CAT25C64S-TE13 ON Semiconductor, CAT25C64S-TE13 Datasheet - Page 6

• Manufacturer Part Number: CAT25C64S-TE13
• Manufacturer: ON Semiconductor

Specifications of CAT25C64S-TE13

• Density: 64Kb
• Interface Type: Serial (SPI)
• Organization: 8Kx8
• Access Time (max): 250ns
• Frequency (max): 3MHz
• Write Protection: Yes
• Data Retention: 100Year
• Operating Supply Voltage (typ): 3.3/5V
• Package Type: SOIC
• Operating Temp Range: 0C to 70C
• Supply Current: 10mA
• Operating Supply Voltage (min): 2.5V
• Operating Supply Voltage (max): 6V
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 8
• Lead Free Status / Rohs Status: Not Compliant

STATUS REGISTER
The Status Register indicates the status of the device.
The RDY (Ready) bit indicates whether the CAT25C32/
64 is busy with a write operation. When set to 1 a write
cycle is in progress and when set to 0 the device
indicates it is ready. This bit is read only.
The WEL (Write Enable) bit indicates the status of the
write enable latch . When set to 1, the device is in a
Write Enable state and when set to 0 the device is in a
Write Disable state. The WEL bit can only be set by the
WREN instruction and can be reset by the WRDI
instruction.
The BP0 and BP1 (Block Protect) bits indicate which
blocks are currently protected. These bits are set by the
user issuing the WRSR instruction. The user is allowed
to protect quarter of the memory, half of the memory or
the entire memory by setting these bits. Once protected
the user may only read from the protected portion of the
array. These bits are non-volatile.
Figure 2. WREN Instruction Timing
Figure 3. WRDI Instruction Timing
CAT25C32/64
Doc. No. 1001, Rev. J
Note: Dashed Line= mode (1, 1) — — — —
Note: Dashed Line= mode (1, 1) — — — —
SO
SO
CS
CS
SK
SK
SI
SI
0
0
0
0
0
0
HIGH IMPEDANCE
0
0
HIGH IMPEDANCE
6
0
0
The WPEN (Write Protect Enable) is an enable bit for the
WP pin. The WP pin and WPEN bit in the status register
control the programmable hardware write protect feature.
Hardware write protection is enabled when WP is low and
WPEN bit is set to high. The user cannot write to the status
register (including the block protect bits and the WPEN
bit) and the block protected sections in the memory array
when the chip is hardware write protected. Only the
sections of the memory array that are not block protected
can be written. Hardware write protection is disabled
when either WP pin is high or the WPEN bit is zero.
DEVICE OPERATION
Write Enable and Disable
The CAT25C32/64 contains a write enable latch. This
latch must be set before any write operation. The device
powers up in a write disable state when V
WREN instruction will enable writes (set the latch) to
thedevice. WRDI instruction will disable writes (reset the
latch) to the device. Disabling writes will protect the
device against inadvertent writes.
1
1
1
0
0
0
Characteristics subject to change without notice
© 2005 by Catalyst Semiconductor, Inc.
cc
is applied.