AT32UC3L0256 Atmel Corporation, AT32UC3L0256 Datasheet - Page 616

• Manufacturer Part Number: AT32UC3L0256
• Manufacturer: Atmel Corporation

Specifications of AT32UC3L0256

• Flash (kbytes): 256 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 50 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 17
• Hardware Qtouch Acquisition: Yes
• Max I/o Pins: 36
• Ext Interrupts: 36
• Usb Speed: No
• Usb Interface: No
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Lin: 4
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 460
• Analog Comparators: 8
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.62 to 3.6
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 18
• Input Capture Channels: 12
• Pwm Channels: 35
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

32145A–12/2011
Figure 26-4. Resistive Touch Screen Pen Detect
The Resistive Touch Screen Pen Detect can be used to generate an ADCIFB interrupt request
or it can be used to trig a conversion, so that a position can be measured as soon as a contact is
detected.
The Pen Detect Mode generates two types of status signals, reported in the Status Register
(SR):
Before a current change is reflected in the SR, the new status must be stable for the duration of
the debouncing time.
Both status conditions can generate an interrupt request if the corresponding bit in the Interrupt
Mask Register (IMR) is one. Refer to
• The bit PENCNT is set when current flows and remains set until current stops.
• The bit NOCNT is set when no current flows and remains set until current flows.
X
Y
X
Y
M
M
P
P
Tristate
GND
GND
Pullup
Touch Screen
Sequencer
Resistive
Section 26.6.11 on page
T o the ADC
AT32UC3L0128/256
610.
D ebouncer
PENDBC
Pen Int er r upt
616