AT83C5136 Atmel Corporation, AT83C5136 Datasheet - Page 33

• Manufacturer Part Number: AT83C5136
• Manufacturer: Atmel Corporation

Specifications of AT83C5136

• Max. Operating Frequency: 32 MHz
• Cpu: 8051-12C
• Max I/o Pins: 34
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 1
• Uart: 1
• Sram (kbytes): 1.25
• Eeprom (bytes): 512
• Operating Voltage (vcc): 2.7 to 3.6
• Timers: 4
• Mask Rom (kbytes): 32
• Watchdog: Yes

12. Timer 2
12.1
7683C–USB–11/07
Auto-reload Mode
The Timer 2 in the AT83C5134/35/36 is the standard C52 Timer 2. It is a 16-bit timer/counter:
the count is maintained by two cascaded eight-bit timer registers, TH2 and TL2. It is controlled
by T2CON (Table 12-1) and T2MOD (Table 12-2) registers. Timer 2 operation is similar to Timer
0 and Timer 1. C/T2 selects F
the timer clock input. Setting TR2 allows TL2 to be incremented by the selected input.
Timer 2 has 3 operating modes: capture, auto reload and Baud Rate Generator. These modes
are selected by the combination of RCLK, TCLK and CP/RL2 (T2CON).
Refer to the Atmel 8-bit microcontroller hardware documentation for the description of Capture
and Baud Rate Generator Modes.
Timer 2 includes the following enhancements:
The Auto-reload mode configures Timer 2 as a 16-bit timer or event counter with automatic
reload. If DCEN bit in T2MOD is cleared, Timer 2 behaves as in 80C52 (refer to the Atmel 8-bit
microcontroller hardware description). If DCEN bit is set, Timer 2 acts as an Up/down
timer/counter as shown in
When T2EX is high, Timer 2 counts up. Timer overflow occurs at FFFFh which sets the TF2 flag
and generates an interrupt request. The overflow also causes the 16-bit value in RCAP2H and
RCAP2L registers to be loaded into the timer registers TH2 and TL2.
When T2EX is low, Timer 2 counts down. Timer underflow occurs when the count in the timer
registers TH2 and TL2 equals the value stored in RCAP2H and RCAP2L registers. The under-
flow sets TF2 flag and reloads FFFFh into the timer registers.
The EXF2 bit toggles when Timer 2 overflows or underflows according to the direction of the
count. EXF2 does not generate any interrupt. This bit can be used to provide 17-bit resolution.
• Auto-reload mode with up or down counter
• Programmable Clock-output
Figure
OSC
12-1. In this mode the T2EX pin controls the direction of count.
/12 (timer operation) or external pin T2 (counter operation) as
AT83C5134/35/36
33