ATtiny10 Atmel Corporation, ATtiny10 Datasheet - Page 17

• Manufacturer Part Number: ATtiny10
• Manufacturer: Atmel Corporation

Specifications of ATtiny10

• Flash (kbytes): 1 Kbytes
• Pin Count: 6
• Max. Operating Frequency: 12 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 1
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 4
• Ext Interrupts: 4
• Usb Speed: No
• Usb Interface: No
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 4
• Adc Resolution (bits): 8
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 0.03
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 125
• I/o Supply Class: 1.8 to 5.5
• Operating Voltage (vcc): 1.8 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 1
• Output Compare Channels: 2
• Input Capture Channels: 1
• Pwm Channels: 2
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

8.2.2
8.2.3
8.3
8.3.1
8.3.2
8127ES–AVR–11/11
ATtiny9
Rev. D
Rev. A – C
Rev. E
Rev. D
•
•
1. ESD HBM (ESD STM 5.1) level ±1000V
2. Programming Lock Bits
Not sampled.
•
1. Programming Lock Bits
•
•
1. ESD HBM (ESD STM 5.1) level ±1000V
2. Programming Lock Bits
ESD HBM (ESD STM 5.1) level ±1000V
Programming Lock Bits
Programming Lock Bits
ESD HBM (ESD STM 5.1) level ±1000V
Programming Lock Bits
The device meets ESD HBM (ESD STM 5.1) level ±1000V.
Problem Fix / Workaround
Always use proper ESD protection measures (Class 1C) when handling integrated circuits
before and during assembly.
Programming Lock Bits to a lock mode equal or lower than the current causes one word of
Flash to be corrupted. The location of the corruption is random.
Problem Fix / Workaround
When programming Lock Bits, make sure lock mode is not set to present, or lower levels.
Programming Lock Bits to a lock mode equal or lower than the current causes one word of
Flash to be corrupted. The location of the corruption is random.
Problem Fix / Workaround
When programming Lock Bits, make sure lock mode is not set to present, or lower levels.
The device meets ESD HBM (ESD STM 5.1) level ±1000V.
Problem Fix / Workaround
Always use proper ESD protection measures (Class 1C) when handling integrated circuits
before and during assembly.
Programming Lock Bits to a lock mode equal or lower than the current causes one word of
Flash to be corrupted. The location of the corruption is random.
Problem Fix / Workaround
When programming Lock Bits, make sure lock mode is not set to present, or lower levels.
ATtiny4/5/9/10
17