ATxmega32A4 Atmel Corporation, ATxmega32A4 Datasheet - Page 57

• Manufacturer Part Number: ATxmega32A4
• Manufacturer: Atmel Corporation

Specifications of ATxmega32A4

• Flash (kbytes): 32 Kbytes
• Pin Count: 44
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 34
• Ext Interrupts: 34
• Usb Speed: No
• Usb Interface: No
• Spi: 7
• Twi (i2c): 2
• Uart: 5
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 12
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 4
• Eeprom (bytes): 1024
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 5
• Output Compare Channels: 16
• Input Capture Channels: 16
• Pwm Channels: 16
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

5.14.3
8077H–AVR–12/09
ADDRCTRL - DMA Channel Address Control Register
• Bit [3:2] - ERRINTLVL[1:0]: DMA Channel Error Interrupt Level
These bits enable the interrupt for DMA channel transfer error select the interrupt level as
described in
123. The enabled interrupt will trigger for the conditions when the ERRIF is set.
• Bit [1:0] - TRNINTLVL[1:0]: DMA Channel Transaction Complete Interrupt Level
These bits enable the interrupt for DMA channel transaction complete and select the interrupt
level as described in
on page
• Bit 7:6 - SRCRELOAD[1:0]: DMA Channel Source Address Reload
These bits decide the DMA channel source address reload according to
can not be changed if the channel is busy.
Table 5-4.
• Bit 5:4 - SRCDIR[1:0]: DMA Channel Source Address Mode
These bits decide the DMA channel source address mode according to
can not be changed if the channel is busy.
Table 5-5.
• Bit 3:2 - DESTRELOAD[1:0]: DMA Channel Destination Address Reload
These bits decide the DMA channel destination address reload according to
58. These bits can not be changed if the channel is busy.
Bit
+0x02
Read/Write
Initial Value
SRCRELOAD[1:0]
SRCDIR[1:0]
123. The enabled interrupt will trigger for the conditions when the TRNIF is set.
00
01
10
11
00
01
10
11
Section 12. ”Interrupts and Programmable Multi-level Interrupt Controller” on page
R/W
SRCRELOAD[1:0]
DMA channel source address reload settings
DMA channel source address mode settings
7
0
Section 12. ”Interrupts and Programmable Multi-level Interrupt Controller”
Group Configuration
R/W
Group Configuration
6
0
TRANSACTION
BLOCK
BURST
FIXED
NONE
DEC
INC
R/W
-
5
0
SRCDIR[1:0]
R/W
4
0
Description
Fixed
Increment
Decrement
Reserved
Description
No reload performed.
DMA source address register is reloaded with initial
value at end of each block transfer.
DMA source address register is reloaded with initial
value at end of each burst transfer.
DMA source address register is reloaded with initial
value at end of each transaction.
DESTRELOAD[1:0]
3
R
0
R/W
2
0
R/W
1
0
DESTDIR[1:0]
Table
Table
XMEGA A
Table 5-6 on page
R/W
5-5. These bits
0
0
5-4. These bits
ADDRCTRL
57