SAM7S161 Atmel Corporation, SAM7S161 Datasheet - Page 340

• Manufacturer Part Number: SAM7S161
• Manufacturer: Atmel Corporation

Specifications of SAM7S161

• Flash (kbytes): 16 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 32
• Ext Interrupts: 32
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 4
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

30.9.6
Figure 30-31. Read Write Flowchart in Slave Mode
340
SAM7S Series
Read Write Flowcharts
SADR + MSDIS + SVEN
Set the SLAVE mode:
Read Status Register
EOSACC = 1 ?
TXCOMP = 1 ?
SVACC = 1 ?
END
The flowchart shown in
in Slave mode. A polling or interrupt method can be used to check the status bits. The interrupt
method requires that the interrupt enable register (TWI_IER) be configured first.
GACC = 1 ?
Figure 30-31 on page 340
programming sequence
Read TWI_RHR
SVREAD = 0 ?
RXRDY= 0 ?
Decoding of the
Change SADR
Prog seq
OK ?
gives an example of read and write operations
GENERAL CALL TREATMENT
Write in TWI_THR
TXRDY= 1 ?
6175L–ATARM–28-Jul-11