STM8S207S8 STMicroelectronics, STM8S207S8 Datasheet - Page 53

• Manufacturer Part Number: STM8S207S8
• Description: Performance line, 24 MHz STM8S 8-bit MCU, up to 128 Kbytes Flash, integrated EEPROM
• Manufacturer: STMicroelectronics

Specifications of STM8S207S8

• Max Fcpu: up to 24 MHz, 0 wait states @ fCPU≤ 16 MHz
• Program: up to 128 Kbytes Flash; data retention 20 years at 55 °C after 10 kcycles
• Data: up to 2 Kbytes true data EEPROM; endurance 300 kcycles
• Ram: up to 6 Kbytes
• Advanced Control Timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, dead-time insertion and flexible synchronization

STM8S207xx, STM8S208xx
10.2
Absolute maximum ratings
Stresses above those listed as ‘absolute maximum ratings’ may cause permanent damage
to the device. This is a stress rating only and functional operation of the device under these
conditions is not implied. Exposure to maximum rating conditions for extended periods may
affect device reliability.
Table 15.
1. All power (V
2. I
|V
|V
V
Symbol
DDx
DDx
SSx
external power supply
cannot be respected, the injection current must be limited externally to the I
injection is induced by V
there is no positive injection current, and the corresponding V
INJ(PIN)
V
V
ESD
IN
- V
- V
- V
DD
SS
SS
must never be exceeded. This is implicitly insured if V
| Variations between all the different ground pins
| Variations between different power pins
Voltage characteristics
DD
Supply voltage (including V
Input voltage on true open drain pins (PE1, PE2)
Input voltage on any other pin
Electrostatic discharge voltage
, V
DDIO
, V
IN
DDA
>V
DD
) and ground (V
while a negative injection is induced by V
Doc ID 14733 Rev 12
Ratings
DDA and
SS
(2)
, V
SSIO
V
DDIO
, V
SSA
)
(1)
) pins must always be connected to the
IN
IN
maximum must always be respected
maximum is respected. If V
(2)
IN
see
sensitivity) on page 86
V
V
<V
INJ(PIN)
SS
SS
Min
-0.3
ratings (electrical
SS
Electrical characteristics
Absolute maximum
- 0.3
- 0.3
. For true open-drain pads,
value. A positive
V
DD
Max
6.5
6.5
IN
50
50
+ 0.3
maximum
53/103
Unit
mV
V