CT300DJH060 Powerex Inc, CT300DJH060 Datasheet - Page 6
![no-image](/images/manufacturer_photos/0/5/537/powerex_inc_sml.jpg)
CT300DJH060
Manufacturer Part Number
CT300DJH060
Description
Manufacturer
Powerex Inc
Type
IGBT Moduler
Datasheet
1.CT300DJH060.pdf
(10 pages)
Specifications of CT300DJH060
Prx Availability
RequestQuote
Voltage
600V
Current
300A
Circuit Configuration
Dual
Rohs Compliant
Yes
< Transfer-molded Power-Module >
CT300DJH060
FOR HIGH-POWER SWITCHING
INSULATED PACKAGE
Correct and Safety Use of Power Module
Unsuitable operation (such as electrical, mechanical stress and so on) may lead to damage of power modules.
Please pay attention to the following descriptions and use Mitsubishi Electric's IGBT modules according to the guidance.
During Transit:
Storage:
Prolonged Storage:
Operating Environment:
Flame Resistance:
Anti-electrostatic Measures:
2011/04
• Keep shipping cartons right side up. If stress is applied by either placing a carton upside down or by leaning a box against
something, terminals can be bent and/or resin packages can be damaged.
• Tossing or dropping of a carton may damage devices inside.
• If a device gets wet with water, malfunctioning and failure may result. Special care should be taken during rain or snow to
prevent the devices from getting wet.
• The temperature and humidity of the storage place should be 5~35°C and 45~75% respectively. The performance and
reliability of devices may be jeopardized if devices are stored in an environment far above or below the range indicated
above.
• When storing devices more than one year, dehumidifying measures should be provided for the storage place. When using
devices after a long period of storage, make sure to check the exterior of the devices is free from scratches, dirt, rust, and so
on.
• Devices should not be exposed to water, organic solvents, corrosive gases, explosive gases, fine particles, or corrosive
agents, since any of those can lead to a serious accident.
• Although the epoxy resin is in conformity with UL 94-V0 standards, it should be noted that those are not non-flammable.
• Following precautions should be taken for MOS-gated devices to prevent static buildup which could damage the devices.
(1) Precautions against the device rupture caused by static electricity
Static electricity of human bodies and cartons and/or excessive voltage applied across the gate to emitter may damage and
rupture devices.
electrostatic build-up and quick dissipation of the charged electricity.
* Containers that are susceptible to static electricity should not be used for transit nor for storage.
* Signal terminals to emitter should be always shorted with a carbon cloth or the like until right before a module is used.
Never touch the signal terminals with bare hands.
* Always ground the equipment and your body during installation (after removing a carbon cloth or the like. It is advisable to
cover the workstation and it's surrounding floor with conductive mats and ground them.
* It should be noted that devices may get damaged by the static electricity charged to a printed circuit board if the signal
terminals to emitter of the circuit board is open.
* Use soldering irons with grounded tips.
(2) Precautions when the signal terminals to emitter is open
* Voltage should not be applied across the collector to emitter when the signal terminals to emitter is open.
* The signal terminals to emitter should be shorted before removing a device from a unit.
Sense-emitter and temperature-sensor are also vulnerable to excessive voltage. The basis of anti-
PEV-M0478-E
6
TENTATIVE