BTS 3028SDL Infineon Technologies, BTS 3028SDL Datasheet - Page 16

• Manufacturer Part Number: BTS 3028SDL
• Manufacturer: Infineon Technologies

Specifications of BTS 3028SDL

• Packages: PG-TO252-3
• Channels: 1.0
• Vds (max): 60.0 V
• Id(nom): 5.0 A
• Rds (on) (max): 30.0 mOhm
• Id(lim) (min): 18.0 A

6
The device provides embedded protection functions. Integrated protection functions are designed to prevent IC
destruction under fault conditions described in the data sheet. Fault conditions are considered as “outside” normal
operation.
6.1
The device is protected against over temperature due to overload and / or bad cooling conditions. To ensure this
a temperature sensor located in the Power MOSFET is used.
The BTS3028SDL has a thermal-latch function. The device will turn off and stay off, even after the measured
temperature has dropped below the thermal hysteresis. After cooling down the device can be switched on again
by toggling the IN pin.
The protective switch off can be reset by setting the input pin voltage to low. Then the internal logic is not supplied
anymore and the next time the voltage on the IN pin rises above the input threshold voltage, the device will switch
on, if the temperature is not above the over temperature threshold.
see
Figure 12
Datasheet
I
High
Low
T
I
IN(nom)
IN(lim)
JSD
Figure
IN
I
0
T
IN
J
12.
ΔT
Protection Functions
Thermal Protection
Error Signal via Input Current at Thermal Shutdown
JSD
Thermal shutdown
16
Smart low side power switch
HITFET - BTS3028SDL
Protection Functions
Rev. 1.0, 2009-12-06
Thermal_fault _latch. emf
t
t
t