1604366-4 Tyco Electronics, 1604366-4 Datasheet - Page 11

• Manufacturer Part Number: 1604366-4
• Description: Metal Shell Micro Circular Threaded Coupling Connectors; ADAPTER,OVERMOLD,7 POS ( Tyco Electronics )
• Manufacturer: Tyco Electronics

3.8. Strain Relief and Wire Dress
When bending or forming wires, hold the wire bundle at least ten times (10X) the diameter beyond the back of
the connector before bending in any direction. Wires must remain perpendicular to the connector and avoid an
excessively sharp bend radius.
3.9. Panel Mounting
Rev
Metal-Shell Micro Circular Connectors
A
A. Cutout
The maximum panel thickness shall be 3.25 mm [.128 in]. The panel must be cut using the dimensions
provided in Figure 17.
B. Mounting
The receptacle assembly can be rear panel mounted. The jam nut is threaded onto the front mating face
of the receptacle assembly until it is flat against the panel. The jam nut must be tightened against the
panel to 2.26–3.95 N
20. Perform a final continuity test on the cable assembly.
Solder Cup Receptacle Panel Cutout
Panel (Ref)
D
m [20–35 in–lbs]. See Figure18.
10.7 +0.05
[.421 +.002]
[.441 +.003]
11.2 +0.08
Tyco Electronics Corporation
Figure 16
Figure 17
Figure 18
[.566 +.002]
14.38 +0.05
Panel Seal O-Ring
13.46 +0.05
[.530 +.002]
Solder Tail Receptacle Panel Cutout
Jam Nut
114-13201
11
of 17