1604366-4 Tyco Electronics, 1604366-4 Datasheet - Page 4

• Manufacturer Part Number: 1604366-4
• Description: Metal Shell Micro Circular Threaded Coupling Connectors; ADAPTER,OVERMOLD,7 POS ( Tyco Electronics )
• Manufacturer: Tyco Electronics

3.6. Cable Selection and Preparation
4 of 17
Metal-Shell Micro Circular Connectors
CAUTION
NOTE
NOTE
A. Cable Selection
Select the desired cable with a wire size range of 0.06–0.2 mm
production requirements. Cable OD is dependent upon the adapter used with the plug connector, refer to
Paragraph 3.5 and Figure 2.
B. Cable Preparation
i
i
!
1. After cutting overall length, place heat shrink tubing (approximately 76.2 mm [3.00 in.] in length, crimp
ferrule (if applicable), and the overmold/shield termination adapter onto the cable. See Figure 3.
2. Strip off 12.7 mm [.50 in.] of the outer cable jacket. See Figure 4.
The 24 AWG wire size is solid or 7-strand only.
Wrapping masking tape around the cable (or other suitable methods) works well at holding the components out of the
way until needed. However, these components may be placed onto the opposite end of the cable at their time of need
if the opposite end is unterminated.
Take care so as to not cut through the shield or the individual discrete wires or conductors.
Tyco Electronics Corporation
Figure 3
Figure 4
2
[30–24 AWG]. Cut overall length to
114-13201
Rev A