CRS1 ETC-unknow, CRS1 Datasheet - Page 9

• Manufacturer Part Number: CRS1
• Description: An Analog Touch Panel Controller Chip Through Serial Crs1-656 ,ps/2 Crs1-685
• Manufacturer: ETC-unknow

Note: i. Send command by ASCII Format.
B. ELO Emulation Mode
T0381, 0892
T0381, 0892
T0380, 0892
Pass
T0380, 0892
T0381, 0892
v. Responding data to the command are usually attached by CR (0DH) at the end
vi. If a command is not duly received or if the command is not contained in the commands
vii. Take longer time than 15 mS between a command and the following command.
:
ii. When sending command, add CR (0DH) at the end.
iii. Either capital letters or small letters are good.
<Example> "DI" Command case
i. Acknowledge ( a )
ii. Diagnostic ( d )
iii. ID ( i )
iv. Owner ( o )
v. Quiet ( q )
vi. Select Stop Mode ( z ) *Gunze original command
list, such the command is ignored (without output).
:
:
Binary Mode
data, commands are received, and commands commanding response (e g. "DI", "VE" &.c)
produce responding data followed by transmission of interrupted position data.
Command is executed immediately upon receiving it. Even if CRS1 is transmitting
SPEC 8.2.00
9